Anywire BS-H0317-1K Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары Anywire BS-H0317-1K. Anywire BS-H0317-1K 9 страниц. Anywireaslink system
Печатать страницу[How to connect]
Connect the transmission line included with the base unit body to the transmission line
from the master unit.
Connect correctly for the polarity of +/-.
Light emitting and
receiving surfaces
UL style 2103
Two cores of No.24 AWG (black) φ4.1
Core nish outside diameter φ1.5
■Example of mounting an LP connector to the end of the transmission line
Applicable LP connector: LP2-PWH-10P
Place the lines in the groove so that the black line (DN) is positioned nearer
the hinge side of the cover, and fold the part A onto the part B side and then
hitch the hook C to x the cover.
A
Hole to pass the clamp
Clamp
Transmission line
Red: DP (+)
Black: DN (-)
B
Cover
C
In this cover-mounted
state, check if the hooks
① and ② are tted.
Insert the body clamp into the hole
of the cover and crimp them with a
dedicated tool.
Dedicated tool: LP-TOOL
③ ④
After crimping, check if the hooks
⑤ ⑥
③ to ⑥ are tted securely.
[Example of installation]
Purchase the bracket separately.
M3 tightening torque: 0.5N・m or less
CAUTION
When securing the unit, allow a margin so that
no stress is applied to the cables and
connecting connectors etc.
Do not tighten the screws excessively.
Doing so may cause a failure.
[Installation Location]
- Location where the unit will not be subject to vibration or shock.
- Places which are waterproof and not directly exposed to dust.
- Where the body is not exposed to waste metal or sputter.
- Places free from condensation.
- Location where the atmosphere is free of corrosive gas, ammable gas, and
sulfur.
- Location where there are no high-voltage or high-current cables.
- Location where there are no cables and controllers that generate servo,
inverter, or other high-frequency noise.
- Location where the unit will not be subject to direct sunlight.
[Precautions for use]
- This unit is used by connecting to the AnyWireASLINK transmission line.
This unit does not operate even if it is directly connected to the I/O card etc.,
of the sequencer.
- Use this unit in a proper voltage range.
① ②
- Also include the attached transmission line included with the unit in total
length.
-BSH03171K 5/8-