3onedata NP5100-2T-32DI Руководство по быстрой установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Сервер 3onedata NP5100-2T-32DI. 3onedata NP5100-2T-32DI 4 страницы.
Печатать страницу
18. Select/confirm button
【Mounting Dimension】
Unit: mm
Notice Before Mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【Rack-mounted】
This product adopts rack-mounting, mounting steps as below:
Step 1
Select the device mounting location to ensure
enough size.
Step 2
Adopt 4 bolts to install the mounting lugs in the
device position as figure below.
Step 3
Place the device in the rack; adopt 4 bolts to fix two
sides mounting lugs in the rack.
Step 4
Check and confirm the product is mounted firmly on
the rack, mounting ends.
【Disassembling Device】
Step 1
Device power off.
Step 2
Adopt screw driver to loosen the 4 bolts fixed on
the mounting lugs in the rack.
Step 3
Shift out the device from rack, disassembling ends.
Notice before power on:
Power ON operation: First insert the power supply
terminal block into the device power supply interface,
and then plug the power supply plug contact and power
on.
Power switch "—" means power ON, "O" means power
OFF.
Power OFF operation: First, put the powers switch to
the "O" side and then disconnect the power supply.
Finally disconnect the connector between the device and
the power cord. Please notice the operation order above.
【Power Supply Connection】
AC power supply
This device provides 2 AC power supply access
interfaces which come with a switch.
The power supply range is 85~265VAC
【Serial Port Connection】
This device provides 3IN1 serial port, which
supports RS232, RS485 and RS422 at the same
time. The interface type is RJ45 and its pin
definitions are as follows:
PIN
1
2
3
4
5
RS-232 DSR RTS GND TXD RXD DCD CTS DTR
RS-485 —
—
GND —
—
RS-422 —
R-
GND R+
—
【Console Port Connection】
The series products provide 1 program debugging port based
on RS-232 serial port which can conduct device CLI command
management after connecting to PC. The interface adopts
RJ45 port, the RJ45 pin definition as follows:
Pin No.
2
3
Pin Definition
TXD
RXD
【DIP Switch Settings】
The device provides 4-pin DIP switch for function
setting, in which ON is the enabled end. DIP switch
definition and operation method as follows:
DIP
Definition
Operation
1
Reserved
－
2
Restore
Set the switch to ON, wait for the
Factory
device to restart automatically, and
Settings
resume the switch before the restart
is completed.
3
Reserved
－
4
Reserved
－
【TF Card Slot】
This device provides 1 TF card slot. Using a screwdriver to
unscrew the screw behind the TF card slot with slight strength
and the card slot would pop up, then put TF card in the slot in
the right way. TF card could be used for device upgrade.
Before using it, please format the TF card into FAT32 format.
Notice:
6
7
8
D-
—
D+
T-
—
T+
5
GND