Anywire Bitty Series Руководство по эксплуатации
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Кабели и разъемы Anywire Bitty Series. Anywire Bitty Series 5 страниц. Poka-yoke terminal
Также для Anywire Bitty Series: Руководство (15 страниц)
Печатать страницу
AnyWire Bitty series POKA-YOKE Terminal
A027XB-02□2-P
Replaceable lever input
The AnyWire System Products Guide describes individual products. Refer to the Guide as necessary.
[Notes on Safety]
Precautions that must be observed in order to use this system safely are indicated as shown below.
You must observe these precautions.
A WARNING indicates a potentially hazardous
situation which, if not handled correctl y, could
result in death or serious injury.
WARNING
System Safety
○
This system is intended for general industrial applications. It does not have functions for supporting applications requiring h igher levels
of safety such as safety-related devices or accident prevention systems. The product must not be used for these purposes.
WARNING
Always turn off the power before attempting to mount or replace.
○
System power supply
○
Use a stable, 24V DC power supply. Use of an unstable power supply may cause problems with the system.
Separately route high-voltage and power cables
CAUTION
○
Although the AnyWire Bitty Series has a high noise margin, keep the transmission line and I/O cables away from high-voltage and power cables.
Connectors and terminals
○
* Pay careful attention to the length and installation of cable wiring to ensure that connectors and cables are neither overloade d nor disconnected.
* Make sure to prevent any metal objects from getting inside the connectors or the terminal blocks.
* Short-circuits caused by metal objects or mis-wiring are likely to damage the device.
Do not impose any external loads on the units. Doing so may cause a failure.
○
○ Do not disconnect or reconnect between the transmission line and slave units. A malfunction may be caused.
○ Do not use for power supply of AnyWire Bitty series and for switching parallel signal for SBC (Single Board Controller) and
controller, etc.
Commonalization of mutual power supply systems may result in system failure.
Use the AnyWire Bitty
○
[Features]
* This product is compatible with the AnyWire Bitty series.
* This product has a replaceable lever switch (input) and
an indication to direct ejection (output) function.
* This product can be laid out with a φ28 pipe.
* Transmission and power supply can be connected with a
4-wire connection.
*
for transmission line connection.
* The distance for transmission is 100 m, and up to 128
units can be connected.
(Power supply to the entire system)
* The lever can be replaced.
[Type]
Bit Operation
One point input
A027XB-02G2-P
One point output
One point input
A027XB-02R2-P
One point output
AnyWire System Products Guide
Eject indicator lamp (Green) (Red)
Eject check input
Eject indicator lamp (Green)
Eject check input
Eject indicator lamp (Red)
CAUTION
[Warranty]
■ Warranty period
The warranty on the delivered Product shall continue to be
effective for one (1) year after the delivery thereof to a
location as designated by the original owne r.
■ Scope of warranty
Should a defect occur in any part of the Product during
the foregoing warranty period when it is used normally in
Manual, the Company shall replace or repair the defect
free of charge, except when it arises as a result of:
[1] Misuse or abuse of the Product by the owner;
[2] Fault caused by other than the delivered Product;
by any person other than the Company's personnel;
[4] Any unusual force of nature, disaster or other cause
beyond the Company's control.
The term "warranty," as used herein, refers to the
warranty applicable to the delivered product alone. The
Company shall not be liable for consequential or
incidental damages resulting from any malfunction.
■ Repair at cost
After the expiration of the warranty period, the owner shall
be responsible for all costs and expenses incurred for the
troubleshooting and repair of the Product. Even during the
warranty term, the Company shall repair any defects
arising from causes other than within the scope of the
-A027XB02*2P 1/5-
A CAUTION indicates a potentially hazardous situation
which, if not handled correctl y, may result in personal
injury or property damage.
1
A027XB-02G2-P
2
LINK
4
8
ADDRESS No.
16
32
64
128
ON
ADDRESS