cascade corporation L Series Руководство пользователя - Страница 13
Просмотреть онлайн или скачать pdf Руководство пользователя для Позиционеры клапанов cascade corporation L Series. cascade corporation L Series 16 страниц. Integral mount fork positioner with integrated sideshift
Печатать страницуP
ERIODIC MAINTENANCE
Daily
Check items shown each day. Report problems to your
supervisor. Refer to service manual for troubleshooting,
maintenance and repair procedures.
250-Hour
Every time the lift truck is serviced or every 100 hours
of truck operation, whichever comes first, complete the
following maintenance procedure:
• Check for loose or missing capscrews, worn or
damaged hoses, and hydraulic leaks.
• Tighten fork carrier retainer capscrews to 100 Nm.
• Tighten cylinder rod anchor bar capscrews to 65 Nm.
• Inspect fork position cylinder anchors for secure nut
retainers.
• Tighten frame carrier stop capscrews to 100 Nm.
500-Hour
After each 500 hours of truck operation, in addition to the
250-Hour maintenance, perform the following procedures:
• Inspect carrier bearings for wear or damage. If bearing
thickness is less than 1.5 mm, replace both bearings.
2000-Hour
After 2000 hours of truck operation, in addition to the 100,
300 and 1000-hour maintenance, forks in use shall be in-
spected at intervals of not more than 12 months (for single
shift operations) or whenever any defect or permanent
deformation is detected. Severe applications will require
more frequent inspection.
Fork inspection shall be carried out by trained personnel
to detect any damage that might impair safe use. Any fork
that is defective shall be removed from service. Reference
ANSI B56.1-2005.
6878149 EN
Fork Carrier
Retainer
Capscrews
Cylinder Rod
Anchor Bar
Capscrews
Cylinders
and hoses
FP2550.eps
Inspect for the following defects:
• Surface cracks
• Straightness of blade and shank
• Fork angle
• Difference in height of fork tips
• Positioning lock
• Wear on fork blade and shank
• Wear on fork hooks
• Legibility of marking
NOTE: Fork Safety Kit 3014162 contains wear calipers,
inspection sheets and safety poster. Also available is fork
hook & carriage wear gauge 209560 (Class II), 209561
(Class III).
WARNING: After completing any service
procedure, always test the fork positioner
through five complete cycles to make sure
the attachment operates correctly before
returning it to the job.
Carrier
Bearings
Cylinder
Anchors
Forks
Frame
Carrier
Stop
Capscrews
11