cascade corporation F Series Руководство пользователя - Страница 16

Просмотреть онлайн или скачать pdf Руководство пользователя для Переключатель cascade corporation F Series. cascade corporation F Series 20 страниц. Double/triple sideshifter

Печатать страницу

PERIODIC MAINTENANCE

Daily

Check items shown each day. Report problems to your

supervisor. See Service Manual for troubleshooting,

maintenance and repair procedures.

WARNING: If the fork locking pin is not

fully engaged, the fork could become

disengaged from the carriage.

1000-Hour

Every time the lift truck is serviced or every 1000 hours

of truck operation, complete the following maintenance

procedures:

• Check for loose or missing bolts, worn or damaged

hoses, hydraulic leaks, and damaged or missing fork

stops.

• Inspect lower hooks for wear and proper clearance.

Adjust if necessary, refer to Installation, step 4.

Tighten lower hook capscrews to 120 ft.-lbs (165 Nm)

• Tighten backrest capscrews (Cascade) to 145 ft.-lbs.

(195 Nm).

• Inspect upper and lower bearings for wear. If any

bearing is worn to less than .09 in. (2.5 mm) thickness,

replace the entire bearing set. Refer to service manual

for replacement procedure.

• Apply general-purpose chassis grease to Sideshifter

upper and lower bearings.

Cylinders and

hoses for leaks

Forks

WARNING: After completing any service

procedure, always test the sideshifter

through five complete cycles. First test with

no load, then test with a load to make sure

the attachment operates correctly before

returning it to the job.

Fork Lock

Pins

Backrest

SS1422.eps

2000-Hour

After 2000 hours of truck operation, in addition to the daily

inspections and 1000-hour maintenance, forks in use

shall be inspected at intervals of not more than 12 months

(for single shift operations) or whenever any defect or

permanent deformation is detected. Severe applications

will require more frequent inspection.

Fork inspection shall be carried out by trained personnel

to detect any damage that might impair safe use. Any fork

that is defective shall be removed from service. Reference

ANSI B56.1-2005.

Inspect for the following defects:

• Surface cracks

• Straightness of blade and shank

• Fork angle

• Difference in height of fork tips

• Positioning lock

• Wear on fork blade and shank

• Wear on fork hooks

• Legibility of marking

NOTE: Fork Safety Kit 3014162 contains wear calipers,

inspection sheets and safety poster. Also available is

fork hook & carriage wear gauge 209560 (Class II).

Fork

Stops

Upper and

lower hook

engagement

Fasteners

6888419-R1