3P Technik DTC200 Руководство по установке и эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Контроллер 3P Technik DTC200. 3P Technik DTC200 16 страниц.

Operation

Mains Voltage – There are exposed electrical conductors inside this appliance. This appliance must be

installed and serviced by a competent electrical technician to the current requirements of BS7671 and IEEE

recommendations. Before servicing this appliance, normal safe isolation procedures should be

implemented.

Do not touch the PCB while energised, it carries mains voltage.

Do not touch any connection terminals while energised.

Do not attempt to service this item when wet, or in a wet or high humidity environment.

If the housing of the control panel becomes damaged, you must shut down and securely isolate this

appliance immediately.

You must connect this appliance to a grounded 3 wire supply, protected by suitable overload protection.

Connected pumps and solenoids are earthed via the control panel, and may otherwise become live.

If the power cables are damaged, either to or from the controller then shut down and isolate this appliance.

Do not attempt to repair any part of the circuit board. Refer to the manufacturer for advice.

DTC200 is a time-delay based controller for chemical dosing of fluids within a processing tank. The

operation cycle consists of tank filling, tank dosing, reaction delay, and tank draining.

Dosing and reaction time are both variable in 1 minute intervals up to 253 minutes duration. Tank filling and

draining are level based.

DTC200 V1.20

Page 8

22/01/20