Danelectro FAB Overdrive D-2 Инструкции - Страница 2

Просмотреть онлайн или скачать pdf Инструкции для Музыкальная педаль Danelectro FAB Overdrive D-2. Danelectro FAB Overdrive D-2 2 страницы.

D-2 Instructions

TO BEGIN:

• Connect instrument cable to the IN jack.

Connect amplifier cable to the OUT Jack. If using

an AC Adapter, connect to DC-9V jack. Or use

9Volt battery (included).

• LED light will be on when foot switch is

activated.

CONTROL FUNCTIONS:

LEVEL: This control sets the level of the output to

the amplifier.

TONE: Rotate this control to adjust the EQ.

OVERDRIVE: Use this control to set the amount of

Overdrive.

caution:

This is a high gain device. Start with the LEVEL

control at 25% and then advance as needed.

FAB

Overdrive

OVERDRIVE:

Adjusts the amount

Adjusts the EQ

of overdrive

INPUT

BATTERY: Uses one S-006P 9-Volt Battery. Danelectro "Vintage Power

Source" batteries are recommended.

BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.

Polarity: Center Negative (-). 300mA maximum. Danelectro "Zero Hum"

Battery Eliminators are recommended.

TONE:

LEVEL:

Adjusts the

output level

9V DC

OUTPUT