AirVerter Gravity MicroFlex MFG-3100 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Краскопульт AirVerter Gravity MicroFlex MFG-3100. AirVerter Gravity MicroFlex MFG-3100 14 страниц. Hvlp paint spray system
Печатать страницу1. Air Compressor that will hold a minimum of
20 PSI at the gun. Important: Position a
pressure gauge at the end of your air hose
next to the gun to be assured of the PSI
required to satisfactorily spray your coating.
1. Attach the air source to the base of the
MFG-3100 Spray Gun
1. Before you use your paint, make certain it is
properly mixed. This is particularly true of
multi-component paints. Use a paint shaker,
rotary mixer, or paint paddle to achieve a
homogeneous mixture.
splitting your paint into two parts; the top will
typically be lighter and the bottom will be
heavier. Completely stir the bottom half of
the paint and slowly add small amounts of
the top half into the heavier bottom.
1. Air pressure forces paint from the paint
container into the fluid chamber of the gun
and out through the nozzle where the flow of
air breaks the paint stream into tiny particles
(atomization), creating the spray.
a. Needle position controls the amount of
paint flowing through the fluid nozzle.
b. Trigger action controls needle position.
c. The Fluid Control Knob (GG-015) at the
rear of the spray gun controls trigger
action. Turning to the right will reduce
fluid flow; turning to the left increases flow.
DO NOT OPERATE SPRAY GUNS WITHOUT PERSONAL SAFETY EQUIPMENT
AirVerter
Gravity MicroFlex Spray Gun
EQUIPMENT REQUIREMENTS
2. High Pressure Air Hose:
START-UP
BEFORE SPRAYING
2. Strain your paint to remove impurities. Use
3. Thin
We recommend
4. Needle packings (GG-024) are preset at the
SPRAYING
2. Adjust the air until you have the desired
3. Align the Flexible Extension (MF-008) to the
4. If you are having problems with the
a. Air hose lengths up to 50 feet MUST
have an I.D. of 3/8 inch.
b. Air hose lengths greater than 50 feet
MUST have an I.D. of 1/2 inch.
.
a cone strainer, or a 100-mesh nylon bag or
equivalent strainer.
your
paint
manufacturer's specifications.
factory and self adjusting. Replace packing
cartridge when necessary.
atomization. Too much air or fluid pressure
will cause the gun to spray improperly and
will create unnecessary overspray! You
need only a small amount of air as you are
atomizing only a small amount of paint.
desired position.
operation of your paint gun, check the
Trouble Shooting Guide at the end of the
manual for possible causes and solutions.
according
to
the