Dukane WMIC2B Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Микрофонная система Dukane WMIC2B. Dukane WMIC2B 2 страницы. Wireless mic system
Также для Dukane WMIC2B: Информация по эксплуатации (2 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство пользователя (16 страниц), Краткое руководство по эксплуатации (2 страниц)
Печатать страницу
Microphone and Transmitter (See images below)
1.
Plug the Clip-on Mic cord into the center MIC phone jack on the Transmitter.
2.
Bring the Mic/ Transmitter within 8 feet of the Speaker.
3.
Turn ON the mini Transmitter ( Power ON). Red LED Signal light will appear.
4.
The transmitter will seek the receiver which is inside the speaker. When matching (pairing) is completed, takes about 3 sec-
onds, a beep-beep sound will be heard, While pairing the transmitter red/blue LEDs will flash. Note: Do not cover the bot-
tom of the transmitter during pairing since an IR LED signal is emitted from the transmitter.
If the matching (pairing) of the system does not occur the MIC TRASMITTER may need to be reset. Turn the MIC
TRANSMITTER OFF. Then press and hold a button on the multifunction switch and turn ON the MIC TRANSMITTER.
Release the button after the red LED comes ON.
5.
The Mic should now be active. Adjust Volume. If no sound is present press the center button on the Multi-functional switch to
change the inputs. Also check to see that the speaker is powered ON.
6.
The MIC talk time exceeds 8 hours. The red LED on the transmitter starts flashing when there is 1 hour of operating time
remaining. Recharge the battery continuously for 4 hours. Use the cable with the USB connector to the USB Power Adapter
or to the USB port on a PC.
Mode Setup – Settings for the AUX AUDIO INPUT on the Speaker
There are 4 modes of operation for the AUX AUDIO input on the top of the speaker unit. This Input is located next to the DC INPUT. The
audio entering this port can be set to operate in one of 4 ways.
Mode 1. MIC Only: Only sound from the Miniature MIC TRANSMITTER is amplified. No AUDIO AUX (it is turned Off)
Mode 2. Mixed audio; The MIC TRANSMITTER and AUX AUDIO INPUT are mixed.
Mode 3. MIC priority operation; The MIC audio, when present, will have the priority and turn off the AUX AUDIO.
Mode4. AUX AUDIO INPUT priority; The Aux IN on the speaker unit will have priority over the Mic input .
Setting the mode. The MIC TRANSMITTER is used to set the mode. Start with it OFF.
Mode 1. Hold down the MIC TRANSMITTER key 1 (Volume up) button and turn ON the power.
Mode 2. Hold down the MIC TRANSMITTER key 2 (Right key) button and turn ON the power
Mode 3. Hold down the MIC TRANSMITTER key 3 (Volume down) button and turn ON the power.
Mode 4 Hold down the MIC TRANSMITTER key 4 ( Left key) button and turn ON the power.
See the figure.
MINIATURE MIC TRANSMITTER
Top View
Red and Blue LED
Optional audio input
WMIC2 QUICK START GUIDE
Multi-function switch
- Top and right side are
Volume increase.
- Center is switch between
MIC and Audio Inputs.
- Bottom and left side are
Volume decrease.
Power adapter or PC
USB port (5 VDC)
Charging cable
Mic Transmitter top view
External Clip-
on MIC
B
( For charging)
DUKANE CORP AV SERVICE DEPT
2900 Dukane Drive
St Charles, IL 60174
800-676-2487
Fax 630-584-5156
http://www.dukane.com/av/service/
Page 2 of 2
Speaker Top View connections