Duluth Forge FNVL30-1 Руководство - Страница 10
Просмотреть онлайн или скачать pdf Руководство для Газовый обогреватель Duluth Forge FNVL30-1. Duluth Forge FNVL30-1 20 страниц. Vented natural gas logs
Печатать страницуWARNING: Never check for
gas leaks with open flame.
1. Generously apply a noncorrosive leak
detection fluid to all connections.
2. Light the burner with the shutoff valve, no
more than half open, and holding a match
slightly in front of the pan (see Lighting
Instructions, page 13).
3. Inspect all connections for bubbles,
raw gas odor, or flame from any area
other than the burner (leaks). If leaks are
detected, shut off the gas valve immedi-
ately. Tighten, or reassemble the loose
connection(s) using pipe joint compound
until burner system is leak free.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
1. Place vermiculite into burner pan. Pull
glowing ember loosely, and sprinkle uni-
formly on the surface of vermiculite as
shown below.
2. Install grate steps (see Figure 8).
Grate
Figure 8 - Grate Steps
10
INSTALLATION
TESTING BURNER FOR LEAKS
INSTALLING LOGS
MODEL FNVL18-1
Grate Steps
www.factorybuysdirect.com
4. When the burner is tested and leak free,
observe the individual tongues of flame
on the burner.
Note: Let the burner manifold cool first
before removing to unclog port blockages.
The burner design includes more ports
on the outside of the bar. Make sure that
all ports are clear and producing flame
evenly across the burner. If any ports
appear blocked, clear them by removing
the burner manifold and reaming the ports
with a modified paper clip or other suit
able tool.
5. When finished testing, turn the gas shutoff
valve OFF to extinguish all flames.
It is very important to install the logs exactly
as instructed. Do not modify logs. Use only
logs supplied with heater.
Each log is marked with a number. This
number will help you to identify the logs when
installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
3. Place log #1 on the grate steps.
4. Place log #2 on the left, front of the grate
base.
5. Place log #3 on the right, front of the grate
base.
Log #2
Vermiculite and Glowing Ember
Figure 9
Log #1
Log #3
200247-01A