Dumor EASYCARD SRA3+ Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Ламинатор Dumor EASYCARD SRA3+. Dumor EASYCARD SRA3+ 8 страниц.

Печатать страницу

# 4 - key

(23)

Selects to stop the machine / move the sheet back / decrease a value.

#2 Selectable menus available (the menu settings a are switched /altered by using the + or - buttons)

- Language :Attention! if you put it in chinese you will not be able to return to English!

- Standard presets or * mode => custom cut length settings

- Mark reader ON or OFF (square in display present or not), if on then there must be a mark on the sheet.

- Mark position compensation + or - in 1/10 mm

- First line position compensation

- Card length compensation

- Gutter cut compensation

- Batch counter and reset

- Total cut counter, not adjustable

- Number of cards to be cut according to the multiple laid out on one sheet press + or - to increase/decrease

- Unjam forward generally not to be used as it will make the jam worse

- Unjam backwards to be used with a gentle pull on the jammed sheet to help it out

- Slit width of the cassette usually factory set at 85 mm. Note it will not change the setting , its just a reminder

- Inch to mm conversion => leave it in mm

- Specify number of slit rows. its just a reminder

- Return to standard factory settings

* Menu for custom cut lengths

To access

Press button # 2 for 4 full seconds

The menu will now be in custom mode

Available data to enter:

- Selection of the first cut line length

- Selection of the card length

- Selection of the cross cut gutter width

- Selection of the nbr of rows of cards per sheet

All selections are in increments of ± 1/10 mm

When you exit the menu the values are memorized until overwritten

Use of the mark reader

Digital printers are easy to use but are very inaccurate as they have no reference point and the print can drift up and down the sheet

and shift from side to side and the image can stretch and shrink at random.

For a high accuracy job like card cutting the cut lines have to be very accurately positioned.

The mark reader will signal the machine to start cutting when the print is in view.

This may increase the apparent print position accuracy on the card as the total print deviates up and down the sheet at random.

Limitations of the mark reader

The mark reader will determine the correct position of the first cut and the relative positions of the follow on linear cuts.

It will not correct the following printer deviations

- Shrink

- Stretch

- Sideways shift

- Image skew

Possible apparent errors in image position when you run a job and ways to correct the cutting to suit.

- Always use a metal precision ruler to determine the error.

- First measure the card and the cross waste lengths.

- Usually they will be spot on if not reset the cut length fractionally using button nr 2.

(21)