Dunavox DAVG-18.46.TO Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Охладитель для вина Dunavox DAVG-18.46.TO. Dunavox DAVG-18.46.TO 16 страниц.

Печатать страницу

Dunavox DAVG-18.46.TO Руководство по эксплуатации

BUILT-UNDER INSTRUCTIONS

Make sure your installation does not block the front

ventilation grille. The unit is designed to fit under

worktops between 820 and 890mm in height. Remove

the adjustable ventilation grille screws and slide it to the

required height. Tighten the screws to lock the grille in

position.

If the unit is fully integrated to be installed for fitting

kitchen plinth, make sure that the ventilation gaps in the

plinth are at least 300 square centimeters and remove

the ventilation grilles, so that warm air can disperse

unhindered. Otherwise the appliance has to work harder,

resulting in an increase in electricity consumption.

NOTE: When pushing the appliance into the niche, make

sure that the mains cable does not get trapped.

FULLY INTEGRATED BUILT-IN-COLUMN

INSTRUCTIONS

The unit door seals the installed unit almost completely,

so an air vent must be provided in the base of the

housing. Warmed air must be conducted via the

ventilation shaft to the rear wall of the housing and then

expelled upwards. The ventilation channels should

measure at least 200 square centimeters in cross-

section.

WARNING: To ensure the proper functioning of the

appliance, air vents should never be blocked or covered.

BUILT-IN CABINET INSTRUCTIONS

Make sure your installation does not block the front

ventilation grille. And be sure the door will open and

close properly in the chosen location.

You can find the detailed installation drawing

the attachment.

ELECTRICAL CONNECTION

WARNING:

Improper use of the grounded plug can

result in the risk of electrical shock. If the power cord is

damaged, have it replaced by a qualified electrician or an

authorized service center.

All electrical work should be carried out by a suitably

qualified and competent person in accordance with local

and national safety regulations.

Check that the voltage marked on the product

corresponds with your supply voltage.

Connect this appliance to a separate, at least 13A circuit.

Connection should be made via a suitable switched

socket which is easily accessible. For extra safety it is

advisable to install a residual current device (RCD) with

a trip current of 30mA.

Have the receptacle and the circuit checked by a

qualified electrician to ensure that the socket is grounded

correctly.

NOTE: In locations where there is frequent lightning, it is

advisable to use surge protectors.

Do not connect the appliance to the mains electricity

supply by an extension lead. Extension leads do not

guarantee the required safety of the appliance (e.g.

danger of overheating).

The appliance must not be connected to an inverter and

must not be used with a plug adapter as these can cause

damage to the appliance's electronic unit.

The cord must rest securely behind the appliance and not

be allowed to lie or hang unprotected.

WARNING:

THIS

EARTHED.

INSTALLING THE HANDLE

IMPORTANT: Do not overtighten the screws & do not

use power tools to install the handle. Overtighten screw

causes glass breakage.

DESIGN 1 –

○

Locate the handle

,1 over the fixing pins

and using the supplied allen key, tighten the securing

○

grub screws

,2 to fix the handle.

DESIGN 2 –

Remove the door gasket

install the handle - you can see two designated holes

for handle installation.

APPLIANCE

MUST

○

,3 of the door

○

on the side you wish to