Danfoss VLT 4000 Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Приводы постоянного тока Danfoss VLT 4000. Danfoss VLT 4000 16 страниц.

After the bottom duct work is positioned in place,

remove the three T25 screws from the outer holes in

the mounting brackets on the sides and front of the

duct work and move them to the inner holes of the

same brackets. Tighten the three screws to the

specified torque.

The bottom duct work is not fastened to the enclo-

sure.

Install the front cover of the duct and the cable

clamp bracket if used. Install the two remaining

gland plates.

Note: The cable clamp bracket is grounded

through the screws that secure the bracket to

the duct. If additional grounding is desired the

grounding strap that is supplied with the kit may

be installed.

Instruction No: 175R5640 V3

Aug 13, 2008

Page 10

Outer hole

Photo 28. Move mounting screws

from the outer hole to the inner hole

Photo 29. Installed ductwork

Inner hole