Dunavox DAB-42.117DB Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Кухонная техника Dunavox DAB-42.117DB. Dunavox DAB-42.117DB 15 страниц.
Также для Dunavox DAB-42.117DB: Руководство по эксплуатации (13 страниц), Руководство по эксплуатации (15 страниц), Руководство по эксплуатации (17 страниц)

Печатать страницу

BUILT-UNDER INSTRUCTIONS

Make sure your installation does not block the front

ventilation grille. The unit is designed to fit under

worktops between 820 and 890mm in height. Remove

the adjustable ventilation grille screws and slide it to

the required height. Tighten the screws to lock the

grille in position.

If the unit is fully integrated to be installed for fitting

kitchen plinth, make sure that the ventilation gaps in

the plinth are at least 300 square centimeters and

remove the ventilation grilles, so that warm air can

disperse unhindered. Otherwise the appliance has to

work harder, resulting in an increase in electricity

consumption.

NOTE: When pushing the appliance into the niche,

make sure that the mains cable does not get trapped.

FULLY INTEGRATED BUILT-IN-COLUMN

INSTRUCTIONS

The unit door seals the installed unit almost

completely, so an air vent must be provided in the

base of the housing. Warmed air must be conducted

via the ventilation shaft to the rear wall of the housing

and then expelled upwards. The ventilation channels

should measure at least 200 square centimeters in

cross-section.

WARNING: To ensure the proper functioning of the

appliance, air vents should never be blocked or

covered.

BUILT-IN CABINET INSTRUCTIONS

Make sure your installation does not block the front

ventilation grille. And be sure the door will open and

close properly in the chosen location.

YOU CAN FIND THE DETAILED

INSTALLATION DRAWING IN THE

ATTACHMENT

ELECTRICAL CONNECTION

WARNING:

Improper use of the grounded plug can

result in the risk of electrical shock. If the power cord

is damaged, have it replaced by a qualified electrician

or an authorized service center.

All electrical work should be carried out by a suitably

qualified and competent person in accordance with

local and national safety regulations.

Check that the voltage marked on the product

corresponds with your supply voltage.

Connect this appliance to a separate, at least 13A

circuit.

Connection should be made via a suitable switched

socket which is easily accessible. For extra safety it is

advisable to install a residual current device (RCD)

with a trip current of 30mA.

Have the receptacle and the circuit checked by a

qualified electrician to ensure that the socket is

grounded correctly.

Note: In locations where there is frequent lightning,

it is advisable to use surge protectors.

Do not connect the appliance to the mains electricity

supply by an extension lead. Extension leads do not

guarantee the required safety of the appliance (e.g.

danger of overheating).

The appliance must not be connected to an inverter

and must not be used with a plug adapter as these

can cause damage to the appliance's electronic unit.

The cord must rest securely behind the appliance and

not be allowed to lie or hang unprotected.

WARNING:

THIS APPLIANCE MUST BE EARTHED.

INSTALLING THE HANDLE

IMPORTANT: Do not overtighten the screws & do not

use power tools to install the handle. Overtighten

screw causes glass breakage.

DESIGN 1 –

Locate the handle ①,over the fixing pins ③,of the

door and using the supplied allen key, tighten the

securing grub screws ②,to fix the handle.

DESIGN 2 –