Danfoss SET 3E Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Термостат Danfoss SET 3E. Danfoss SET 3E 16 страниц. Electronic 24 hour programmer for heating and hot water
Также для Danfoss SET 3E: Руководство пользователя (12 страниц)

Печатать страницу

Outline of

programmer

Leave at least

25mm below

product

Rear entry

cable access

5. Referring to the wiring diagrams on page 6-12, connect the unit

as shown.

6. The unit is supplied ready for use in systems having PUMPED

primaries. Should the unit be required for use in a system having

GRAVITY primaries, remove the small link located on the rear of

the unit. The link, which is clearly labelled can be found on the

bottom RIGHT hand side of the unit.

7. Ensure all dust and debris are cleared from the area.

8. Locate the module on the latches at the bottom of the wallplate

and hinge upwards to fully engage the unit connectors into the

wallplate. Tighten the two ﬁ xing screws to secure the unit to the

wallplate.

9. Before setting the programme, check the unit and circuit. Switch

ON the mains supply and press both WATER & HEATING rocker

switches to the ON position - both red LED's should now be

illuminated. Adjust any remote thermostat to check the services

operate correctly.

10. Then press both WATER and HEATING rocker switches to the OFF

position and check that both services do not operate.

11. Finally, press both WATER and HEATING rocker switches to

TIMED position prior to programming the unit.

Danfoss Heating

C/L

Cable aperture

knockouts

Leave suﬃ cient space

for screwdriver access

Terminal

block

Wall or

plasterbox

ﬁ xing