Danfoss TP5000 RF Si Руководство по установке и инструкции по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по установке и инструкции по эксплуатации для Термостат Danfoss TP5000 RF Si. Danfoss TP5000 RF Si 14 страниц. 5/2 day programmable electronic room thermostat
Также для Danfoss TP5000 RF Si: Руководство по установке (14 страниц), Инструкции пользователя (2 страниц)
Печатать страницу
Commissioning (RF models only)
To tune the RX receiver to the frequency of the thermostat signal,
follow steps 1-5 below.
Step 1
TP5000-RF
Reset the unit by pressing and holding
-, +, V and
Step 2
Press and hold V and +
buttons for 3 seconds
(TP5000 now transmits
unique signal continuously
for 5 minutes)
Step 3
RX1
Press and hold buttons
PROG and CH1 for
3 seconds until green light
fl ashes once.
Step 4
RX2 (if applicable)
Stat 1 - perform steps 1-3
Stat 2 - wait 5 mins, perform steps 1-2 and then
RX3 (if applicable)
Stat 1 - perform steps 1-3
Stat 2 - wait 5 mins, perform steps 1-2 and then
Stat 3 - wait 5 mins, perform steps 1-2 and then
Step 5
TP5000-RF
Press V or
revert back to operating mode.
6
together until display goes blank.
press PROG and CH2 on RX2
press PROG and CH2 on RX3
press PROG and CH3 on RX3
to select temperature - the unit will