Danfoss TP7000 Series Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Термостат Danfoss TP7000 Series. Danfoss TP7000 Series 11 страниц. Electronic programmable room thermostat
Также для Danfoss TP7000 Series: Руководство по установке (9 страниц), Инструкции по установке Инструкции по эксплуатации (14 страниц)

Clock display (12 or 24 hr)

Press and hold NEXT & DAY (for 2-3 seconds)

until display change.

(AM or PM will appear in 12 hr mode)

1.5 Setting the Clock & Day

Press

PROG

DAY - Press DAY until correct day is shown

(1=Monday, 2=Tuesday etc).

TIME - Press + and - to change time (press

and hold to change in 10 min increments).

1.6 Setting the OSC Period, if enabled

This display will ONLY appear if the OSC

function has been enabled by your installer.

Use the + or - buttons to select the OSC

period. The choices are 0:30 (30 mins), 1:00

(1 hr), 1:30 and 2:00.

The recommended setting is 0:30. If set to

0:00 the function is disabled.

1.7 Accepting the preset programmes

If you are happy to use the preset programmes on page 6, you don't

need to do anything else. To accept these settings just close the

front cover and after 2 minutes the pre-settings will automatically be

accepted.

The unit is now in RUN mode (colon ﬂ ashes

in display) and the heating will operate

according to the preset programmes.

Danfoss Heating

begin

programming.