Danfoss Weatherhead COLL-O-CRIMP T-480 Руководство по настройке и эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по настройке и эксплуатации для Водяной насос Danfoss Weatherhead COLL-O-CRIMP T-480. Danfoss Weatherhead COLL-O-CRIMP T-480 14 страниц.
Печатать страницуT-480-TA Set-Up & Operating Instructions
1. Open vent screw on pump reservoir before
operation. Release the pusher clip and slide
pusher back. NOTE: Periodically lubricate the
die ring with Weatherhead T-400-G lubricant.
When crimping with Coll-O-Crimp® I tooling,
insert the T-420-25 adapter die ring into the
base plate. Insert the proper sized collet.
4. Holding uncrimped hose assembly in place,
refer to the PowerSource crimp spec tool at
danfoss.com/crimp for correct spacer ring.
Note: when crimping spiral-reinforced hose
(H430, H439, H470), a T-480-68 spacer ring
must be used to prevent damage to the
pusher. Position spacer ring on top of collet
with proper side of spacer ring facing up as
shown in figure B, page 12 and slide pusher
forward, making sure pusher clip has locked.
10 | PORTABLE COLL-O-CRIMP® Model T-480 Set up and operating instructions | 2022.10.
2. Select the proper Weatherhead hose
and end fitting. Insert the hose into the
end fitting, making sure that the hose is
bottomed in end fitting. For insertion depth
information, reference figure A, page 12.
Pressure
position
5. Attach air supply and depress pressure end
of treadle and hold until spacer ring contacts
the base ring, indicating that the crimp is
complete.
3. Loosen knob and tilt press as necessary.
Insert hose assembly from below the base
plate and between the collet halves. Align
dimples or knurl band on end fitting with
top of collet, making sure that collet halves
are evenly matched. When crimping H757
hose, position end fitting as shown in figure
D, page 12.
Release
position
6. Depress the release end of treadle to retract
pusher. Release the pusher clip and slide the
pusher back to access tooling. Remove the
spacer ring and the crimped hose assembly
from below the base plate and between the
collet halves.
!
NOTE: Visually inspect the crimped end.
Check the nominal crimp diameter and verify
that the crimp is within 1/16" from the locating
dimples on the collar, see figure C, page 12.
.
BC425482205281en-000101