AETOOL BSA-12 Руководство пользователя - Страница 3

Просмотреть онлайн или скачать pdf Руководство пользователя для Мультиметр AETOOL BSA-12. AETOOL BSA-12 7 страниц. Battery & starter analyser

Печатать страницу

•

Do not add distilled water if the electrolyte is covering the top of the pla

during the recharging process, it will get warm and expand.

during the recharging process, it will get warm and expand. After recharging has been

completed, recheck

•

Do NOT smoke or cause sparks or flames while the battery is being recharged

because batteries give off explosive gasses.

Preparing for Test:

1. The Tester operates from 9V ~ 15V DC and should not be tested on 24V directly. It will cause

damage the unit. For 12V x 2 batteries (in series or parallel), disconnect the connections and

test them individually.

2. Battery that has just been charged by the charger contains surface charge and it should be

discharged by turning ON the Head lights for 3~5 minutes before testing.

3. Always attached the tester clips on the lead side of the battery terminal posts during testing

Always attached the tester clips on the lead side of the battery terminal posts during testing

so that it has a good contact. This will provide better and accurate results.

4. Do not attach the tester clips directly onto the steel bolt that tightened to the battery terminal

Do not attach the tester clips directly onto the steel bolt that tightened to the battery terminal

posts; this may give inaccurate readings or inconsistent results. (Note: This also applies to all

other battery testing methods.)

5. During testing on the battery whist it is still in the car, make sure the engine

During testing on the battery whist it is still in the car, make sure the engine, all accessories

During testing on the battery whist it is still in the car, make sure the engine

and load are OFF. Close the trunk lid and all doors.

6. Inspect the battery for cracks or broken casing. Do not use the Teste

Inspect the battery for cracks or broken casing. Do not use the Tester if the battery is

damaged.

7. If the battery is a WET type: non sealed maintenance free, top up the level

If the battery is a WET type: non sealed maintenance free, top up the level as specified by

If the battery is a WET type: non sealed maintenance free, top up the level

the markings on the battery

the markings on the battery with distilled water. This will help to purge the gas from the cells.

DO NOT OVERFILL.

8. If necessary to remove the battery from the vehicle to test, ALWAYS remove the negative

terminal from the battery first. Make sure all accessories are OFF so that you do not cause

any arcing.

OPERATION:

Battery Test:

1. Make sure the battery terminals are clean. Wire brush

Make sure the battery terminals are clean. Wire brush them if necessary. Clamp the

black clip to the battery negative terminal and red clip to the battery positive terminal.

clip to the battery negative terminal and red clip to the battery positive terminal. The

clip to the battery negative terminal and red clip to the battery positive terminal.

Tester LCD will light up.

add distilled water if the electrolyte is covering the top of the plates because

add distilled water if the electrolyte is covering the top of the pla

recheck the level.

smoke or cause sparks or flames while the battery is being recharged

from 9V ~ 15V DC and should not be tested on 24V directly. It will cause

een charged by the charger contains surface charge and it should be

od contact. This will provide better and accurate results.

. Close the trunk lid and all doors.

remove the battery from the vehicle to test, ALWAYS remove the negative

. This will help to purge the gas from the cells.

them if necessary. Clamp the Tester

After recharging has been

r if the battery is