Conqueror CIL-BD800S Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Открыватель двери гаража Conqueror CIL-BD800S. Conqueror CIL-BD800S 14 страниц. Chain and belt openers

Печатать страницу
www.conquerordoors.com

9.Trouble shooting

Trouble
The opener can't work, without
display on LED
The opener can't work, LED
display 1.
Door stops before it is fully up on
opening cycle; LED display 2.or 3.
Door auto-reverses before reaching
the ground on closing; LED display
3.
The door can't run to the closing
door direction, LED display 4.
O p e n e r s t o p s a f t e r a m o m e n t
r u n n i n g , L E D d i s p l a y 7
O p e n e r c a n n o t r u n a n d L E D
d i s p l a y 8
Push button can operate normally,
but can't remote control
The remote distance became very
near distinctly, the brightness of
indicator lamps became lower
distinctly
Remoter can operate normally, but
the push button has no function
The product appearance and functions will be changed by development without further notice.
Reason
●Opener is not power on
●Fuse of main control board
damaged
●Travel adjustment error
●The closing resistance is
greater than that system set
load activates the barrier
protection system
●The closing resistance is
greater than that system set
load activates the barrier
protection system
● The light of photo beam
have been shielded;
●System started to use photo
beam system, but it hasn't
been connected.
speed sensor wire is loosed
speed sensor is broken
DC motor wire is loosed
DC motor is broken
control board is broken
● The transmitter has not
learned
● It has no battery in the
transmitter
●The battery power is not
enough
● Push button loose or broken
circuit
11
Solution
●Switch on the power, inspect
" POWER" socket
●Change the same type fuse.
●Readjust limit position
●Inspect and adjust the door balance
system
●Inspect and adjust the door balance
system
i n c r e a s e d o o r c l o s i n g l o a d
● Remove the barrier in the beam road.
● Prohibit using photo beam or
connect the photo beam
reconnect the wires
change speed sensor
reconnect the wires
change DC motor
change control board
● Learn transmitter according to the
manual
● Change the battery of transmitter
●Change the battery
● Inspect push button wiring