Daniamant Echopilot FLS 3D Руководство - Страница 10

Просмотреть онлайн или скачать pdf Руководство для Сонар Daniamant Echopilot FLS 3D. Daniamant Echopilot FLS 3D 17 страниц. Forward looking sonar

Industrivej 24C

DK-3550 Slangerup

Denmark

FLS 3D

Tel. +45 4737 3800

Fax: +45 4737 3809

www.daniamant.com

Transducer Interface Installation

The transducer interface requires reasonable protection from moisture. Ensure that you mount it

within reach of the transducer cables and the data cable.

All the plugs on the transducer interface have a threaded locking ring in order to prevent them from

coming loose through vibration, and to protect from moisture. Do not over tighten these locking rings.

The transducer plugs are both 8pin mini din plugs. Make sure that the correct transducer is

connected to the correct plug. Each transducer is clearly marked with either port or starboard. The

transducer interface is also clearly marked showing which socket is for the port transducer and which

is for the starboard.

The data cable has a five-pin mini din plug, there is only one socket on the transducer interface that

this will plug into, which is clearly marked data.

The power cable plugs into the socket that is marked power. The power cable has two cores, red

(positive +12 / 24v), and black (negative 0v).

The transducer interface will require four mounting screws or bolts which will go through the

stainless-steel mounting brackets. We advise the use of stainless-steel fixings.

Do under no circumstances unscrew the two mounting brackets!

As shown on the diagram below the spacing for the fixings is 157 mm x 172mm.

FLS 3D Manual Version 1

Daniamant A/S