Dura Faucet DF-NMK301 Руководство - Страница 2

Просмотреть онлайн или скачать pdf Руководство для Сантехническая продукция Dura Faucet DF-NMK301. Dura Faucet DF-NMK301 2 страницы. Designer single pedestal goose neck rv kitchen faucet

Печатать страницу

IN S T A LLA T IO N O F T H E F A U C E T

Remove Mounting Nuts

Remove the mounting nut (10) and

washers (8 & 9) from threaded collar of

the spout (6). Remove the mounting nut

(5) and nylon washer (4) from the threaded

collar of the body (2). Note that the black

rubber gasket (3 & 7) at the base of the

faucet body (2) and spout (6) remains in

place to create a seal after the faucet is

installed.

Install Faucet Spout

Install the faucet spout (6) through the

hole in the sink. Slide washers (8 & 9) to

the threaded collar followed by the

mounting nut (10). Thread the mounting

nut to the underside of the sink and

tighten.

Install Faucet Body

Install the faucet body (2) through the hole

in the sink. Slide the nylon washer (4) up

to the threaded collar followed by the

mounting nut (5). Thread the mounting nut

to the underside of the sink but do not

tighten yet.

Position Faucet Body

Determine the direction you would like the

handle to face when in the off (down)

position. Generally, when installed in the

center of the sink, this would be straight

forward and when installed in the corner,

it would be positioned diagonally across

the sink. Center the faucet through the

hole in your sink and then hold the faucet

body (2) in place. Tighten the mounting

nut until the faucet is secure being careful

not to over tighten.

Connect Hoses

Connect the spout supply (13) to the

faucet spout. After doing so, connect the

hot water supply to the longer of the two

flexible supply hoses and the cold water

supply to the shorter. Flexible supply

hoses are complete with ½-inch I.P.S.

fittings for your convenience. We have

also included nose cone washers and

brass supply nuts for use with copper

tubing.

Remove Aerator and Check

Water Connections

Remove the aerator from the end of the

spout and run the water for 30 to 60

seconds to flush the lines. While doing

this check to ensure that all of the

connections are tight and there are no

leaks. Reinstall aerator.

M A IN T E N A N C E A N D C LE A N IN G

Cleaning Tips: The finish on your product

is designed to retain its beautiful sheen

for years. To maintain the original look of

the finish, a little care and caution should

be used. We recommend the use of mild

soap and water to clean the product.

THE USE OF ABRASIVE CLEANERS MAY

SCRATCH THE FINISH OR CAUSE

OTHER DAMAGE.

R E C O M M E N D E D T O O L S A N D

M A T E R IA LS

Adjustable Wrench

Plumbers Tape (Thread Seal

Tape)

Phillips Screw Driver

B E F O R E Y O U B E G IN

There are a variety of things to do before

installing any new plumbing system into

your home or residence. Before you begin

work make sure you:

Shut off the main water supply

Cover your drain to prevent

loss of parts

Observed any local plumbing

codes

Inspect fixture for damage -

Replace as necessary

Dura Faucet reserves the right to make

any revisions in the design of products

without notice.