Brama BR-DWSH01-S Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Посудомоечная машина Brama BR-DWSH01-S. Brama BR-DWSH01-S 14 страниц.
Печатать страницу
STEP 2 ADJUST LEVELING LEGS
• Move the dishwasher close to the installation loca-
tion and lay it on its back.
Adjust
Installation
Height
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4" less than installation height.
STEP 3 REMOVE TOEKICK
• Remove the 2 toekick screws. Lift off the piece
toekick.
Installation Instructions
1
6
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired. Use
power cord kit WX09X70910 available for purchase from
an authorized GE
parts d
ealer. The power cord and
connections must comply with local codes and
ordinances.
• Recommended power cord length is 54" min. and
64" max.
Remove
Junction Box
Cover
Green wire to Green wire ( Ground)
• Connect incoming
power cord white (or ribbed)
to dishwasher white, black
(or smooth) to black and ground to dishwasher green
wire. Use
cUL/
UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 5 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape. Do not use
plumber's putty.
• Install a 90° elbow onto the water valve.
• Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the bottom
of the
dishwasher.
Black wire to Black wire ( Hot)
White wire to White wire ( Neutral)
right