Caslon Maxit 927 Руководство по эксплуатации и техническому обслуживанию - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Ламинатор Caslon Maxit 927. Caslon Maxit 927 13 страниц.
Также для Caslon Maxit 927: Руководство по эксплуатации и техническому обслуживанию (12 страниц)

1. Turn on the motor switch located at the front of the machine. Feed the print in with one

hand and catch it as it comes out with the other hand. Do not let the print drop down as it

exits. Turn off the motor after coating the print.

: the motor should not be left running

for more than 30 minutes at a time or it will overheat and cut out. The motor will only start

to operate again when it has cooled down.

2. For longer prints, such as posters, take the leading edge as it exits and guide the print

back towards the front of the Maxit. The small upper roller is also driven and will assist with

guiding the poster back towards the operator.

Stock type

Most photo paper has a resin coating on the back and should be run at a slightly lower

temperature. If the temperature is too high the heat will affect the resin coating. This will

cause the photo paper to stick to the roller and go under the stripper fingers. If you

experience this adjust the temperature knob from the 12 o'clock position to the 11 o'clock

position. You will then need to wait 25 minutes for the temperature to drop.

You should use a minimum stock of 120gsm and for these papers should apply a thin

coating and set the temperature slightly higher. If the paper is too thin, it will receive cut

marks from the stripper fingers at the rear of the coating roller or rotate around the roller

and not release properly

Mounting

After coating your print, MX adhesive will not dry out, so you can mount your print at any

time. However, with RP adhesive the substrate must be mounted within 2 minutes or

adhesion may be affected. The adhesive will stick to most surfaces including plastic, metal

and wood. After rolling down your print, you will immediately receive a permanent bond.

Maximum adhesion will be achieved after 24 hours.

For smaller prints, simply line up the print on your substrate, then roll it down to eliminate

air, ensuring it makes proper contact with the substrate.

When lining up large prints place the board or other substrate on the table and place silicone

release paper on top of the board leaving the top two inches uncovered. The silicone paper

will keep the print from sticking while lining up the print. Then roll down the print to the first

two inches and slide down the release paper as you roll down the rest of the print. Save the

silicone release paper and use it as many times as needed.

To further improve bonding for RP adhesive, pass the glued sheets through a laminator,

pressure roller system or hand roller to ensure a permanent bond is achieved.

Page 6