Addonics Technologies CDC5HXAES Руководство

Просмотреть онлайн или скачать pdf Руководство для Хранение Addonics Technologies CDC5HXAES. Addonics Technologies CDC5HXAES 4 страницы.

Печатать страницу

IMPORTANT

There is no back door for the Cipher tower encrypted hard drives if

the Cipher keys are lost or stolen.

Cipher key

Check to make sure you have the

correct version of the Cipher key. A

sample key is shown

Black label AES-256 stands for Cipher

256-bit key.

To ensure there is a spare key, your Cipher tower comes with

Cipher keys. These cipher keys have all identical encryption code unless

you requested then to be coded differently. One of these keys should be

kept in a safe and secure location and can be sent back to Addonics for

duplicating additional keys. If you are down to the last key, be sure to

make a back up of all the data stored inside your Cipher tower prior to

sending the last key to Addonics. Addonics is not responsible for key lost

in the mail or retrieval of the data inside the encrypted hard drive.

Keeping track of the hard drive

If you are using the Cipher tower to encrypt multiple hard drives, it is

important to label your hard drive if you are taking the drive out of the

Cipher tower. The hard drive from the Cipher tower that is encrypted will

look like a brand new drive when attach directly to the SATA controller of

a computer. There will be no partition or any hint to indicate that the drive

contains encrypted data. When the drive is partitioned, all the encrypted

data will be lost.

The same holds true if a hard drive already has data on it is installed into

the Cipher tower. The computer detects the hard drive as a brand new

drive or a drive that is unallocated. Once you proceed to partition the

drive, the data that was on the hard drive will be erased and cannot be

recovered.

Installing drives into the Cipher Tower

Refer to Diamond Cipher enclosure hard drive installation guide

II.

Connecting the power cable and Cipher Tower to the computer

Connect the power cord provided from the wall outlet to the back of

the Cipher Tower.

A power switch is located on the front of the tower. Make sure the

power is off on the switch (power LED light should be off)

Connect the provided eSATA or USB2.0 cable from the back of the

Cipher tower to the eSATA or USB2.0 on the computer. We

recommend connecting the eSATA port for best performance if this

port is available on your computer.

ADDONICS TECHNOLOGIES

Slide the enclosure into the drive bay.

Using the key provided, insert it to the lock

mechanism and turn it to the "LOCK"

position. This will secure the enclosure and

provide power to the drive.

Note: It is recommended to fill up the tower

with SATA drives from top to bottom. This

is to help in identifying which drives

connects

which

ports

troubleshooting.

Model: CDC5HXAES

Cipher

keyhole

HDD

Power LED

HDD

Activity LED

5 pairs of

III.

5-port HPM-XA mounted on the Cipher Tower

for

easier

SATA port 5

SATA port 4

SATA port 1

eSATA host port

SATA port 3

SATA port 2

Locking

mechanism

Power Switch

Cipher tower power LED

HDD Activity LED 1

HDD Activity LED 2

HDD Activity LED 3

HDD Activity LED 4

HDD Activity LED 5

eSATA port

Power Connector

Power Switch

Floppy power

connector

buzzer

RAID settting

jumper block (J4)

Error and drive activity

LED jumper block (J1, J3)