aevit VIC 2.0 Руководство по установке и эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Блок управления aevit VIC 2.0. aevit VIC 2.0 17 страниц. Voice interactive controls
Печатать страницуVIC 2.0 INSTALLATION
INSTALLATION STep 10 - INSTALLINg THe VIC 2.0 MICrOpHONe
The following figure shows the components of the VIC 2.0 microphone:
MICrOpHONe
Before mounting the VIC 2.0 Microphone in the vehicle, there is a few things to remember:
1.
It is necessary to position the microphone with the client
Typical locations to mount the VIC 2.0 microphone include the "B" pillar or the upper left roof
support trim panel that runs between the "A" and "B" pillar.
2.
Avoid sharp bends of the gross adjustment section of the microphone:
3.
The microphone should be as un-intrusive as possible:
The microphone should be mounted such that in
comes from behind the client's head with the Gross
Adjustment as straight as possible then curve to
the client with the Fine Adjustment as shown in
the figure to the right. Since is important for the
microphone to be as un-intrusive as possible, the
best location for the microphone itself is slightly to
the left of the clients mouth. This is also shown in
the figure to the right.
Once the microphone is in position, mark the holes where the base plate needs to be mounted then
unscrew the Base Plate from the Gross Adjustment section of the microphone. Use the (2) 3/16" ex-
ploding rivets provided to mount the base plate to the vehicle then reattach the microphone to the
Base Plate.
FINe AdJUSTMeNT
SeCTION
COrreCT
BASe pLATe
grOSS AdJUSTMeNT
SeCTION
in the vehicle:
MICrOpHONe
wIre
INCOrreCT
VIC 2.0 INSTALL MANUAL
3-5