Audioplex INWALL IR TARGET PACKAGE Руководство по установке
Просмотреть онлайн или скачать pdf Руководство по установке для Приемник Audioplex INWALL IR TARGET PACKAGE. Audioplex INWALL IR TARGET PACKAGE 2 страницы.
Печатать страницуINSTALL ATION MANUAL
INWALL IR TARGET, CEILING IR TARGET PACKAGE
Connector:
Mounting:
Remotes:
Range:
Acceptance angle:
Wire:
Power:
Your IRTarget is designed to act as a remote receiver and processor of infrared signals.
This sensor will receive signals from remote controllers and send these signals to a remote
repeater. This allows remote operation of any unit from the room where the IRTarget is located.
CAUTION: Take care to make sure that the IRTarget installation is NOT IN THE LINE OF
SIGHT OR REFLECTION with the repeater. If radiation from the repeater is picked up by this
sensor, a feedback situation is created which will result in instability and unreliable operation.
Undesirable reflection can occur off of light colored walls, windows, mirrors, and even shiny wood
finishes! Also note that the wiring of the unit varies, depending on the type of infrared equipment
that is being used (see back of this page for wiring diagrams). Please call if you have any questions
about your installation.
Any standard type of wire can be used. Shielded or coaxial cable is not usually required
unless the wire passes through some unusually high electrical interference regions.
Prepare the wire leads to and from the IRTarget by stripping about 1/4" of insulation from
each of the ends. Twist strands tightly together so that none stick out to cause a possible short
circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in order.
Your AUDIOPLEX TECHNOLOGY IRTarget is covered by a Lifetime warranty against
defects in workmanship and materials. Any defects will be remedied without charge for labor or
parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered
by this warranty. AUDIOPLEX TECHNOLOGY is not responsible for defective operation caused
by abuse or by modification or service by an unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the
warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The
products must be returned expences prepaid, with written authorization from the company. The
unit must be shipped with the proof of purchase and in the original carton and packing material
to avoid damage.
TECHNOLOGY
Used as a remote receiver and processor
SPECIFICATIONS:
Pigtails.
Fits into most standard single electrical junction boxes.
Will handle almost all standard remote controllers (Note: does NOT work
with B & O equipment, which requires a proprietary confirmation talk-back
function).
110 feet indoors, 15 to 20 feet in direct sunlight.
+ or - 55 degrees off center.
Uses conventional unshielded "zip" or telephone wire.
12 VDC @ 500 mA (unregulated (equals 15 volts), Included with packages)
INSTALLATION:
WARRANTY
DX
(Patent Pending)
2003 - 11/11/03