Beldray EH0089 Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Крытый камин Beldray EH0089. Beldray EH0089 15 страниц. Conception wall fire

Печатать страницу

Thermal Cut-Out Device

This Conception Wall Fire is fitted with a thermal safety cut-out system, built-in to prevent

it overheating. Should the Conception Wall Fire start to overheat, the thermal safety cut-out

system will automatically operate and the Conception Wall Fire will switch off. The Conception

Wall Fire will only resume normal operation when it has cooled sufficiently.

When the thermal safety cut-out activates, the Conception Wall Fire should be left to cool for

approximately 15 minutes before using again.

Before turning the Conception Wall Fire back on, check that there is nothing obstructing the

airflow or blocking the air intake.

Bulb Replacement

Always unplug the Conception Wall Fire from the mains power supply and leave it to cool

completely before attempting to replace a bulb.

Remove the pebbles from the trim.

Loosen the two screws holding the semi-opaque cover in position and then remove the cover.

Remove the defective bulb by pulling it out of the holder. Replace with a 28 W 230 V SES E14 bulb.

Reassemble the Conception Wall Fire by fixing the semi-opaque cover back on and then

replacing the pebbles.

Note: Due to the indeterminate life span and the ease of replacement, the bulbs are specifically

excluded from the guarantee provided with this product.

Caution: Take care not to touch the bulbs with bare hands.

Troubleshooting

Problem

The Conception Wall Fire is

not operating.

The fan is not running.

No heat or light is being

emitted from the Conception

Wall Fire.

No light is being emiited from

the Conception Wall Fire.

Cause

The thermal cut-out device

has operated.

There may be a problem

with the power supply to the

Conception Wall Fire.

The bulb has blown.

EH0089 Conception Wall Fire

Solution

Replace the fuse.

Leave the Conception Wall

Fire to cool for 15 minutes

then switch it back on.

Check the mains power

supply by plugging in a working

appliance. If the mains power

supply is functional and the

cord or plug of the Conception

Wall Fire is suspected to be

faulty, have it checked by a

qualified electrician.

Check the bulb by

replacement.