Constellation Pictor Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Constellation Pictor. Constellation Pictor 17 страниц. Line stage preamplifier

Печатать страницу

Control screens

Many functions of the Pictor are controlled through the LCD touchscreen.

Here is how the control screens function:

Standby

This screen appears if you touch the touchscreen when the rear-panel master

power switch is flipped up. Pushing the onscreen Power button (or the Standby

button on the remote) will power up the Pictor and put it into warmup mode.

Powering on

This screen appears after you press the onscreen Power button or the Standby

button on the remote while the Pictor is powered down. It indicates that the Pic-

tor is in warmup mode. No buttons will function when this screen appears. After

about 10 seconds, the Pictor will become active and an input screen will appear.

Powering off

This screen appears for about 10 seconds if you push the Standby button under

the middle of the front touchscreen or on the remote while the Pictor is powered

on. It indicates that the amplifier is powering off and going into Standby mode.

No buttons will function when the screen appears.

Input selector (Home)

This screen appears when the power is on and the unit is warmed up. Touching

any input button onscreen will switch to that input. The setup screen can be ac-

cessed from this screen using the multifunction button below the display.

Volume/balance

When you select an input, this screen will appear. It provides a large volume

display as well as the display for the balance control. The balance control

functions only when this screen is shown. Pushing the multifunction button

under the Setup label enters the input setup screen.

Note that when the input screen is displayed, the phase of the Pictor's output

can be switched using the button under the fourth indicator on the lower part of

the touchscreen (identified by the red arrow in the screen at right). When the

phase is positive (normal) the indicator will read PHASE+. When the phase is

flipped, the indicator will read PHASE-. Phase can also be switched using the

Phase button on the remote control.