Constellation audio Inspiration PREAMP 1.0 Руководство пользователя - Страница 11
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16 страниц.
Также для Constellation audio Inspiration PREAMP 1.0: Руководство пользователя (16 страниц)
Печатать страницуNormal Operation
Once the amplifier is installed and properly set up, it normally requires no user operation except for turning
the amplifier on and off.
Other than the power button on the front panel, the only control that you might want to use on a regular basis
is the mute function, which can be activated from the front power button or the rear mute switch. However,
this function is provided mainly as a convenience—you would normally use the mute function on your preamp
or the pause button on your source device to mute the sound from your audio system.
Maintenance
The Inspiration MONO 1.0 and Inspiration STEREO 1.0 require no regular maintenance.
If the amplifier's surface becomes dusty, simply wipe it off with a soft dry cloth. Do not spray cleaners on the
surface.
To clean fingerprints from the surface of the amplifier, spray a small amount of mild window cleaner such as
Windex onto a soft dry cloth, then use the cloth to remove the fingerprints. Do not spray the cleaner directly
onto the amplifier.
If dust collects inside any of the amplifier's vents, vacuum it out with a hand vac or shop vac. Use a brush
attachment if available in order to avoid scratching the surface of the vents. If you do not have a brush
attachment, do not touch the surface of the vent with the nozzle of the vacuum, in order to avoid scratching
the surface.
Troubleshooting
Amplifier will not turn on
1. Check to see if the front status indicator LED is illuminated red. If it is not, try the following steps in order.
If any one of the steps restores the power, there is no need to continue to the next steps.
A. Make sure the master power switch on the rear of the amplifier is turned on.
B. Check to make sure the AC cord is connected to the amplifier and to a wall outlet.
C. Flip the master power switch off and on again. This will reset the amplifier's internal circuit breaker.
D. Check the circuit breaker in the electrical box to make sure it has not been tripped. If it has, check to
make sure a short circuit does not exist at the amplifier's speaker terminals or the speaker's input
terminals. If no short circuit exists, flip the breaker on and off to reset it.
E. If none of these conditions restores power, it is likely one of the amplifier's internal fuses is blown. Do
not attempt to change the fuse yourself—the amplifier requires the use of special high-voltage fuses
that are not commonly available. Contact your Constellation Audio dealer for service.
2. If the front status indicator LED is illuminated red, push the left side of the front power switch bar and hold
it for 3 seconds. The LED should begin flashing green. If it does, wait for 1 minute for the amplifier to warm
up. When the LED turns blue, the amplifier is ready to use. If the LED glows red but does not change color
when you push and hold the power switch, contact your Constellation Audio dealer.
Amplifier is on but no sound is produced
1. Make sure the front status indicator LED is glowing blue, indicating that the amp is warmed up and in
active mode. If the LED is glowing red, push it and wait 1 minute for the amp to warm up and the LED to glow
blue. Sound should now be restored.
11