Dantherm 4000 Series Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Кондиционер Dantherm 4000 Series. Dantherm 4000 Series 17 страниц.
Печатать страницуOperation
Introduction
The unit can operate on the built in operation panel. All operation parameters are set via TTL
or SD card. Cooling and heating setpoints are available in the control panel.
Key operation
The functionality on the control panel is as follows:
•
Left key is step up
•
Middle key is step down
•
Right key is enter
12
Up
Down
Enter
Fig. 8
Operation, continued
Navigating menu
Menu structure and navigation. Step up/down to jump through menues, end enter to select
the parameter to read or change.
Step
Hibernate mode shows the actual room temperature. After 3 minutes without
any activity on the keys, the controllers exits any any menu and shows this.
Use up/down to select any below menu
CooL
Cooling set-point parameter
Heat
Heater set-point parameter
Err
Operation error list. See complete list
at section "Error list" on page 14
Test
Over ride test. This will run a series of
component tests. See complete list
at section "Steps in test program" on
page 14
Toggle Celsius to
In hibernate mode press and hold the Enter key for 5 seconds to toggle Celsius and
Fahrenheit readings
Fahrenheit unit in all temperature readings.
Actions
Display
24
Press enter 2 sec. and change the value
C25
followed by enter to save.
Press enter 2 sec. and change the value
H05
followed by enter to save.
Press enter 2 sec. and change the read-
E05
ings to see if more error are present
simultaneously.
Press enter 2 sec. to start the test. The
test steps will increase by one after 60
seconds or be changed manually with
up/down. The test will auto disable
after 30 minutes, if not manually left
before, with enter key
13