cassini C-900135EQ3 Руководство - Страница 10
Просмотреть онлайн или скачать pdf Руководство для Телескоп cassini C-900135EQ3. cassini C-900135EQ3 16 страниц. 900mm x 135mm
Печатать страницуTO MOUNT :
)
1 REMOVE ELECTRONIC RED DOT FINDER FROM BOX
)
2 LOOSEN THUMB SCREWS ON SIDE OF FINDER AND SLIDE FINDER ONTO DOVETAIL
MOUNT LOCATED AT TOP OF MAIN TELESCOPE TUBE.
)
3 TIGHTEN THUMB SCREWS
TO CHECK ALIGNMENT WITH MAIN TELESCOPE IMPORTANT
)
1 THE ELECTRONIC
WILL ALLOW YOU TO ADJUST THE ALIGNMENT.
)
2 DURING THE DAY LIGHT HOURS AIM THE MAIN TELESCOPE AT AN OBJECT AT LEAST 1 4
MILE OR MORE IN THE DISTANCE AND BRING IT INTO FOCUS.(VERY IMPORTANT)
)
3 ONCE YOU HAVE CENTERED THE REFERENCE ITEM IN THE MAIN TUBE TIGHTEN ALL
KNOBS AND ADJUSTMENTS TO PREVENT ANY MOVEMENT.
)
4 REMOVE CIRCULAR BATTERY SAVER LOCATED BENEATH FRONT OF FINDER (BE SURE.
TO SAVE AND REPLACE THE BATTERY SAVER WHEN NOT IN USE.)
)
5 TURN FINDER ON BY SLIDING ON/OFF SWITCH FORWARD.
ON THE RIGHT SIDE OF THE FINDER.
)
6 LOOK THROUGH THE FINDER AND LOCATE THE RED DOT
)
7 IF THE OBJECT IN THE
MAIN TELESCOPE TUBE, ADJUSTMENT IS REQUIRED.
)
8 TO MOVE THE RED DOT UP AND DOWN SIMPLY TURN THE ELEVATION SCREW LOCATED
ON THE REAR BOTTOM OF THE FINDER TO HEIGHT REQUIRED.
)
9 TO MOVE THE RED DOT LEFT AND RIGHT SIMPLY TURN THE WINDAGE SCREW LOCATED
AT THE FRONT LEFT SIDE OF THE FINDER TO THE PROPER POSITION.
)
10 THESE ADJUSTMENTS WILL ALLOW YOU TO POSITION THE RED DOT ON THE SAME
OBJECT CENTERED IN THE MAIN TELESCOPE.
C A S S I N I
ELECTRONIC
MOUNTING ALIGNMENT
.
RED DOT
FINDER IS NOT PRE SET AT FACTORY THE FOLLOWING
,
RED DOT
FINDER IS NOT THE OBJECT YOU SEE THROUGH THE
RED DOT
FINDER
.
-
ON/OFF SWITCH IS LOCATED
.
,
,
10
™
:(
!)
.
,
/