Cast LAVA Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Дровяная печь Cast LAVA. Cast LAVA 20 страниц.

Печатать страницу

Variety

Beech

Oak

Elm

Poplar

Larch*

Spruce*

Scots pine *

Paper and carton must be used only for ignition.

The combustion of wastes is FORBIDDEN and it may damage the stove and the chimney, causing health

damages and spread of bad smell.

The wood is not a fuel which allows a continuous operation of the appliance, as a consequence the heating

all over the night is not possible.

ATTENTION: the continuous and protracted use of aromatic wood (eucalyptus, myrtle etc.) quickly

damages the cast iron parts of the product.

15. LIGHTING

IMPORTANT: The first time that the appliance is lit, there will be an odor given off which disappears after a

short use. It must be ensured that, in any case, a good ventilation of the environment exists. Upon the first

ignition we suggest loading a reduced quantity of fuel and gradually increasing the calorific value of the

equipment. The odors and smoke are regular occurrences which originate from the stabilization of paint

with which the parts have been protected, that is why it is necessary that the room is ventilated.

Therefore, it is extremely relevant to take these easy steps during the lighting:

1. Make sure that a sufficient air change is assured in the room where the appliance is installed.

2. During the first starts, do not load excessively the combustion chamber (about half the quantity

indicated in the instructions manual) and keep the fire continuously ON for at least 6-10 hours

with the regulators less open than the value indicated in the instructions manual.

3. Repeat this operation for at least 4-5 or more times, according to your possibilities.

4. Then load more and more fuel (following in any case the provisions contained in the installation booklet

concerning maximum load) and keep the fire on for a longer time period.

5. During the first starts, no object should be leaned on the appliance or touch enameled surfaces.

6. Once the «break-in» has been completed, it is possible to use the product as per instruction

Kg/m3

750

900

640

470

660

450

550

* wood not suitable for burning

Kwh/Kg moistness 20%

4,0

4,2

4,1

4,4

4,5

4,4