Audiotec Fischer Match PP 86DSP Руководство - Страница 5
Просмотреть онлайн или скачать pdf Руководство для Усилитель Audiotec Fischer Match PP 86DSP. Audiotec Fischer Match PP 86DSP 15 страниц. 8-chanell amplifier with integrated 9-chanell dsp
Печатать страницу
Initial start-up and functions
8 Fuse
the internal fuses the LED lights up red. The fuses
may only be replaced by identically rated fuses (2 x
9 +12 V
Connect the +12 V power cable to the positive ter-
minal of the battery. Recommended cross section:
min. 10 mm² / AWG 8.
REM
10
The remote input has to be used to turn on/off the
PP 86DSP if the signal source which is connected
to the System Connector or Highlevel Input E + F is
not activating the "automatic turn-on" function (Auto
Remote
deactivated by a remote signal applied to the re-
mote input.
The remote lead should be connected to the remote
output / automatic antenna (aerial positive) output
of the head unit / car radio. This is only activated
if the head unit / car radio is switched on. Thus the
head unit / car radio. This input needn´t to be as-
signed if the System Connector or Highlevel Input
E + F is used.
GND
11
The ground cable should be connected to a com-
mon ground reference point (this is located where
the negative terminal of the battery is grounded
to the metal body of the vehicle) or to a prepared
metal location on the vehicle chassis i.e. an area
which has been cleaned of all paint residues. Rec-
ommended cross section: min. 10 mm² / AWG 8.
Auto Remote
12
The PP 86DSP will be turned on automatically if
the highlevel inputs of the System Connector or the
Highlevel Input E + F are used or if a signal is ap-
plied to the remote input (REM) terminal.
The Auto Remote switch allows to activate / deac-
tivate the automatic turn-on feature. The feature
should be deactivated if there are e.g. disturbing
Note: If the automatic turn-on function is deactivat-
ed it is mandatory to use the remote input to power
18
in this case.
Remote Out
13
We strongly recommend to use this output for turn-
the Mono Line Outputs of the MATCH PP 86DSP.
This is essential to avoid any interfering signals.
This output is activated automatically as soon as
the booting process of the DSP is completed. Ad-
ditionally this output will be turned off during the
"Power Save Mode" or a software update process.
Control Input
14
This multi-functional connector is designed for
MATCH accessory products like a remote control
which allows to adjust several features of the am-
or on the remote control itself.
USB Input
15
Connect your personal computer to the PP 86DSP
using the provided USB cable. The required
downloaded from the Audiotec Fischer website
Please note: It is not possible to connect any USB
storage devices.
Status LED
16
The LED indicates the operating mode of the ampli-
Green:
Setup 1 is loaded.
Orange:
Setup 2 is loaded.
Red:
Undervoltage protection circuit is
active.
Internal setup storage is empty (A
new setup has to be loaded via
the DSP PC-Tool software).
Control pushbutton
17
The Control pushbutton allows the user to switch
between the two setup memory positions. To switch
between the setups the button has to be pressed
and held for one second. Switching is indicated by a
Status LED. Pressing the but-
of the Status LED.
.