DURASONIC DS25L Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Ультразвуковой очиститель ювелирных изделий DURASONIC DS25L. DURASONIC DS25L 17 страниц. Ultrasonic cleaners

Печатать страницу

Cleaning Items

NOTE: To stop ultrasonics at any time, press red off button.
Step
Action
1
Set the TIMER for the amount of time you wish the items to be cleaned.
2
Place the items into a basket.
3
Slowly lower the basket into the tank. Do not allow items to contact the tank
bottom.
4
When items are clean and time is up, slowly remove them from the cleaner.
5
Rinse the clean items with clean water and dry them, if necessary.

Draining Your Cleaner

2L, 3L, 4L, and 6L models do not have a drain. To empty, use the side of the rim to
pour the used solution into a waste disposal unit, rinse the tank thoroughly and refill with
new solution.

Optimizing Your Cleaner

Cleaning - check the tank for contamination whenever you change solution. If
necessary, remove contaminants with a nonabrasive cloth and water.
Emptying - always unplug the cleaner before emptying the tank. Empty the solution into
a waste disposal unit.
Filling - always unplug the line cord before filling the tank. Fill the cleaner to the
operating level (one inch from the top with beaker/tray in place), using warm tap water.
Low solution level - will cause the cleaner to fail. When you remove heavy or bulky
loads from the cleaner, the solution level may drop below the operating level. If so, be
sure to replace lost solution and degas, if necessary, depending on the amount used.
Overload - do not rest any items on the tank bottom. Weight on the tank bottom
dampens sound energy and will cause damage to the transducer. Instead, use a tray
and/or beaker positioning cover to support all items. Allow at least one inch between the
tank bottom and the beaker or receptacle for adequate cavitation.
Covers - allow the cleaner to heat up faster, to a higher temperature, and avoid
excessive liquid evaporation.
Heater - the heater may cause some discoloration of the tank wall. This is normal and
will not affect the performance of the unit.
Warning
Do not immerse the cleaner in water.
Unplug the cleaner from the power source.
10