Duratool D03172 Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Паяльный пистолет Duratool D03172. Duratool D03172 2 страницы. Mini soldering station
Печатать страницу
power switch (I=ON/0=OFF). When turned on, the power switch is lit.
•
Always put the soldering iron on the holding rack when it is heating up or during
breaks from soldering.
•
Always keep tips tinned before switching off or storing for any period of time.
•
Lower the temperature during breaks; this saves energy and extends the durability
of the soldering tip.
•
Wait about 2-3 minutes until the soldering tip reaches the adjusted temperature,
test the temperature by touching the soldering tip with solder and if the solder
melts away easily, you can start soldering.
•
Tin the hot soldering tip with solder and wipe off any excessive solder on the wet
cleaning sponge.
•
Heat up the soldering location with the soldering tip and add the solder.
•
Let the soldering point cool down.
•
Clean the soldering tip on the wet sponge each time after soldering.
•
After finishing soldering, put the soldering iron on the rack and turn off the
soldering station at the main switch.
•
Do not file off the soldering tip, in order to avoid causing damage.
•
Never touch the soldering tip.
•
Allow time for the soldering iron to cool down after use.
MAINTENANCE
•
Tip replacement or cleaning should only be done when the iron is turned off and at
room temperature or below.
•
The tip can be changed or replaced simply by unscrewing the knurled nut barrel.
•
After removing the tip, remove any oxide dust that may have formed in the tip
retaining area of the barrel.
•
Replace the tip, then screw the retaining knurled nut barrel, using just hand
pressure to tighten.
•
Do not overtighten as this could damage the element.
•
Pliers should only be used to tighten the nut if loosening occurs when the iron is
hot, to avoid burning your fingers.
CLEANING
•
Clean the outer case of the iron and the station with a damp cloth and a small
amount of liquid detergent.
•
Never submerse the unit in liquid or allow any liquid to enter the case of the
station.
•
Do not use any chemicals, abrasives or solvents that could damage the soldering
station.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronic Equipment (WEEE). Any WEEE marked products
must not be mixed with general household waste, but kept separate for the
treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
V.1.0