DAPAudio D2181 Руководство по эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для DJ оборудование DAPAudio D2181. DAPAudio D2181 16 страниц.
Печатать страницуis not suitable for connecting an additional mixing console, FX- unit, etc. You have to use the LINE-
inputs, when connecting this kind of equipment.
Note: When connecting signal sources, please make sure that the corresponding channel faders and
the master faders are at minimum settings. Otherwise, unpleasant plug-in noise can occur.
6. MIC 2 Level
Controls the volume of the Mic 2.
7. DJ MIC Level
Controls the volume of the DJ-Mic.
8. PFL
The PFL button (pre fade listening) is designed to route the channel input to the monitor section
independent of the individual channel's volume fader setting. It is possible to assign more than one
channel simultaneously to the PFL bus.
inputs per channel
12. Channel Fader
A logarithmic 50mm fader, which controls the volume of its' channel. The faders should be positioned
within range of -12dB to 0dB, leaving you with sufficient room to allow precise matching of
differences in the channel's level settings. The overall volume is set with the master fader. Even though
the channel faders offer an additional gain of +6dB, it is better not to exceed the +0dB position by
default.
13. Selection Switch (Line 1/Line 2)
With this switch you can select between two sets of inputs per channel of inputs per channel.
14. Fader Start A
This switch activates the fader start function for the channel selected by X-assign A (15).
15. X-assign A
Use this switch to assign the Right-side of the crossfader (16) to an input channel (zero is Off).
16. Crossfader
The crossfader allows you to mix evenly from one channel to another channel.
17. X-assign B
Use this switch to assign the Left-side of the crossfader (16) to an input channel (zero is Off).
18. Fader Start B
This switch activates the fader start function for the channel selected by X-assign B (17).
9. Selection Switch (Line 1 Phono/ Line 2)
With this switch you can select between two sets of
of inputs per channel. Set the CD/PHONO (36, 37, 38)
selector in phono position if you want to connect a
turntable. To the PHL1 (48, 50, 52) input on the rearpanel.
10. PFL
The PFL button (pre fade listening) is designed to route
the channel input to the monitor section independent of
the individual channel's volume fader setting. It is
possible to assign more than one channel simultaneously
to the PFL bus.
11. Gain
Use this control to match the connected devices
optimally to your DS-CM-6. The fader set to 0dB.
Adjust the gain with a loud input signal in such a way
that the overload led does not light.
7