Duratuf GL95 Инструкция по сборке Руководство - Страница 11
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Хранение на открытом воздухе Duratuf GL95. Duratuf GL95 16 страниц.
Печатать страницу
ASSEMBLE FRONT PANEL
SELECT:
3 x 1.980 Wall Sheets
1 x 1.980 1Pan Wall Sheet
1 x 2.690 Top Plate (Red)
1 x 2.690 Bottom Plate (Green)
2 x 1.980 Door Jamb Flashings
44 x 30mm Galv Clouts
21 x Rivets
STEP 1:
• Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface
as shown.
NOTE:
The Doorway is standard at 708mm from left-hand end.
To shift the doorway to the right-hand side of the front
wall, simply measure 708mm from the right-hand end.
STEP 2:
• Using 2 x 30mm clouts, nail the Door Jamb Flashing flush
with the top of the Top Plate at the correct measurement as
shown in plan view. Pre drill holes using a 3.5mm drill bit
• Check the distance between the top and bottom plates then
use a further 2 x 30mm clouts to nail the Door Jamb Flashings
to the bottom Plate. Pre drill holes.
STEP 3:
• Place 3x Wall Sheets and 1 x 1Pan wall sheet on timber, en-
suring wall sheets fit underneath door jamb flashings.
• Ensure that the top of the sheet is flush with the top of the Top
Plate and that the sides of the wall sheets overhang the Top
Plate by 15mm as shown. Nail wall sheets to Top Plate (two
clouts per pan)
• Nail the wall sheets to the Bottom Plate making sure that the
Plates are the correct distance apart and that the sides of the
wall sheet overhang the Bottom Plate by 15mm.
• Drill & rivet Door Jamb Flashings to wall sheets using four riv-
ets equally spaced on each side.
NOTE:
Door can be hinged on either side.
STEP 4:
• Place the door on the panel (In open position, approx 20mm
below top of top plate). Using two rivets, rivet the top and bot-
tom hinges to the Door Jamb Flashing, ensuring door closes
properly.
• Fit remaining rivets.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
1948mm
15mm
15mm
10
TOP PLATE
BOTTOM PLATE
TOP PLATE
DOOR OPENING
708mm
960mm
x3
x3
x3
.
1948mm
TOP
PLATE
NAIL
DOOR
JAMB
15mm
15mm