Addonics Technologies NAS25HDU2 Руководство по быстрой установке

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Шкаф Addonics Technologies NAS25HDU2. Addonics Technologies NAS25HDU2 4 страницы. Mini nas
Также для Addonics Technologies NAS25HDU2: Руководство пользователя (8 страниц), Руководство пользователя (13 страниц)

Печатать страницу

Addonics

T E C H N O L O G I E S

Model: NAS25HDU2

Quick Install Guide

FCC Warning Statement

This equipment has been tested and found to comply with the limits for a class B digital

device pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy. If not installed and

used in accordance with the instructions, it may cause harmful interfer ence to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If the equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment on and off, the user

is encouraged to try and correct the interference by one or more of the following

suggestions.

Reorient or relocate the receiving antenna

Increase the distance between the equipment and the receiver

Connect the equipment to a different power outlet other than the one where receiver is

connected

Consult a certified television or radio technician

Mini NAS

For more detailed information on setting up the mini NAS, refer to the User

Manual located on the CD that came with the device.

Follow the instructions to help you connect, setup, and configure it.

Note:

Any 2.5" SATA drive that you connect to the mini NAS will initially be

required to be formatted. This means, if you are connecting a 2.5" SATA

drive with data on it, the hard drive will be formatted erasing all the

information. It is recommended that a backup of this drive be made.

Network Environment

There are 3 different setup conditions you can choose:

A. Setup mini NAS as a DHCP Client:

If the mini NAS is connected to a LAN network with an active DHCP server,

it will obtain an IP address from DHCP server automatically.

B. Setup mini NAS as DHCP Server:

If your LAN network does not have an active DHCP server, the mini NAS will

immediately act as DHCP server and assign itself an IP address for

installation.

C. Setup mini NAS in Static IP environment:

You first need to configure the IP address for mini NAS to operate in the

static IP environment. For Configuring details, please refer to "LAN Config"

setup page.

Mini NAS Hardware Installation

Connect LAN cable to uplink port to LAN switch and/or router.

Connect 5V power adapter then power up the mini NAS.

On / Off Power

Switch

5V Power Jack

To open the mini NAS, remove the 2

screws located at the bottom part of the

enclosure.

Insert the SATA drive into the SATA

connector and secure the drive using the

screws provided.

Factory Reset

Button

Uplink port to

Network Link /

router

Access LEDs

USB port for

print server