Contemporary Research ICC-ZS2 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер Contemporary Research ICC-ZS2. Contemporary Research ICC-ZS2 17 страниц. Lg/zenith superport controllers
Также для Contemporary Research ICC-ZS2: Технические характеристики (2 страниц), Просмотр товара (1 страниц)
Печатать страницу
Using the IC-RC Remote for On-Screen Menus
In order to complete the setup, you'll need the IC-RC IR Remote to use the On-Screen Menus. Typically, the
remote is shipped ready to communicate to Smart TV. Just in case, here's how to set the IR codes in the
remote:
1. Press and hold the Select button and a numeric key for the code # below.
2. Release the two keys at the same time.
3. The remote will now send the selected codes.
4. Remote will keep the codes, even if battery power is lost.
IR Code Format
Zenith Smart TV
LG/Zenith Smart LCD
On-Screen Setup Menus
The remaining installation steps use the IR remote and the TV's built-in character generator.
1. Touch Menu, then 999, then Enter.
2. The text CR MENU> should appear on the screen.
3. Key in one of the commands shown below, then press Enter to activate.
4. Note that, in Menu mode, the Channel Down key acts as a backspace/delete key and Channel Up
can act as an Enter.
Command
All
45677
45678
45679
65478
65479
65487
65482
ICC2
65480
65481
65483
Contemporary Research
Function
The following commands are used for all units
Display firmware base data (variations for LG models)
Display firmware version
Display the unit's Device #. At this point, you can use the Channel Down key as a
Delete key, enter a new device # with the remote's numeric keypad, then hit Enter
to save the new number.
Reset unit, similar to disconnecting power then restarting.
Disable smart port communication. After about 5 seconds the TV will drop
communication with the TV controller and revert to stand alone TV mode. At this
point, the installer can switch to the TV Mode on the remote control, and then
adjust the TV setup parameters. To re-enable smart port, press Record on IC-RC.
Initialize to factory default settings: Power on, unlocked, display channel 11,
channel ring set to 4, 5, and 11, Group 0. Note that this command works even if TV
power is off or control is locked out.
Shows Net RX if receiving the iC-HE's "heartbeat" pulse once per second, !NET RX
if not. Also displays receive signal strength in the ICC2.
The following commands are used for the ICC2 only
Enable constant Net transmit to the Head-End. This is used for measuring the signal
strength of the ICC2 unit's RF output. Press Enter to stop transmitting, or the unit
will automatically stop after 50 seconds.
Display ICC2 transmitter frequency control voltage – should be 2000 - 3150.
Display DF transmitter frequency deviation – should be 245 - 300.
Code
1
5
6
ICC-ZS2 Zenith SuperPort Card