APLICOM A9 IPEX Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для GPS APLICOM A9 IPEX. APLICOM A9 IPEX 12 страниц.
Печатать страницу
TECHNICAL DATA
Supply voltage
Current consumption
GPS antenna power
supply
Fuse
Operating temperature
Storage temperature
Relative humidity
Power switch
Common connections
Note 1:
Ensure SIM cards operating temperature range from telecom service provider.
WARNINGS
•
Warranty is voided if case is damaged.
•
A9 IPEX device and all peripherals must be powerless during the installation. Turn off ignition and
disconnect power.
•
GPRS may interfere sensitive electronics.
•
All devices connected to A9 IPEX device must have a fuse protection.
•
All signal inputs connected to A9 IPEX must be fuse protected, max 3A.
•
As a rule, when pulling Aplicom cables through inlets or tubes during installation, it is not allowed to
pull directly from connectors. Instead the pull must be directed to cable itself.
•
Do not install unit in places were safety may be compromised.
•
Ensure CAN connection and limitations from vehicle manufacturer or dealer.
•
For replacing the internal battery see document K520016 A9 IPEX battery replacement guide
available on Aplicom extranet. DO NOT USE OTHER BATTERIES THAN APLICOM DELIVERED.
RISK OF EXPLOSION.
•
DISCONNECT ALL CABLES FROM A9 IPEX connectors before changing internal battery.
FCC compliance information
For products using SDoCa compliance information statement shall be supplied with the product at the time of
marketing or importation, containing the following information:
a) Identification of the product, e.g., name and model number;
b) A statement that the product complies with the rules; and
c) The identification, by name, address, and telephone number, or internet contact information, of the
responsible part.
§2.1077 (a)(3) The identification, by name, address and telephone number or Internet contact information, of
the responsible party, as defined in §2.909. The responsible party for Supplier's Declaration of Conformity
must be located within the United States.
For FCC Part 15 devices §15.19(a)(3):
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The
End user must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Changes
6,8...32Vdc (nominal +12Vdc)
Typical: < 100mA
Max (peak): 1A / < 1s
3Vdc
External fuse on power cable: 3A
Internal fuse: 3A/slow
-30C...+70C (see Note 1)
-5C...+60C With internal battery
0C...+45C internal battery charge
-40C...+80C
+95% max
None, IGN and SW controlled
Internal GSM /GPRS antenna
Internal GPS/GLONASS antenna
Dimensions
92mm (W) x 151mm (L) x 46mm (H)
Weight
250g + cable 150g
Housing / material
IP67, PC + 10%GF
User interface
SIM card slot (inside the unit)
Indicators (LED):
Led - JAVA appl.(inside the unit)
Options
CAN option
Warranty
1 year
CE marking/Approvals
according to directives:
2004/108/EC
1999/05/EC
ECE r.10.05 E-type approval
7