APlusLift HW-10KOH Руководство по установке и эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Подъемные колонны APlusLift HW-10KOH. APlusLift HW-10KOH 20 страниц. 2-post over head car lift 10,000lb capacity
Также для APlusLift HW-10KOH: Руководство по установке и инструкции по эксплуатации (17 страниц)

Печатать страницу

APlusLift HW-10KOH Руководство по установке и эксплуатации

Step 2 (Installing Columns)

 Bolt each column extension to each column.

 Determine the side that power unit column will be located. The power unit column can

be located on either side. Keep in mind this is the column where your main electrical

power supply will be connected. It is recommended to locate the power side with the

passenger side of the vehicle when loaded on the lift in order to save steps during

operation.

 Double check measurements and make sure that the base plate of each column is

square and aligned with the chalk line.

 Stand up the power unit column (the one a power unit bracket welded on) and position

it inside the chalked lines. The column should face straight toward the other column.

 Stand up the other column opposite to the main power unit column inside the chalk

lines.

 Using a tape measure, measure from back corner to back corner of the base plate to

assure columns are square to each other. Adjust the columns as needed to obtain the

best fit.

 Drill anchor holes with 3/4 inch drill bit into concrete following Anchoring Tips on page

 Assemble washers and nuts on the anchors and then tap into each hole with a rubber

hammer until washers rest against the base plate. Do not tighten anchor bolts at this

time.

 Use a level to check the level of each column. Place horseshoe shims under the base

plate (near the anchor bolts) as needed. This will prevent bending column bases.

 Tighten 10 anchor bolts and recheck for level. Hammer the anchor bolts all the way

down. Tighten anchor bolts using a torque wrench to 125 ft. / lb. DO NOT use an

impact wrench when tightening the anchor bolts!

 Manually lift the carriage on each column about waist high. Let carriages down and

allow them to set on safety latch stops. Make sure they are at the same height. Double

check the latches before working under the carriages.