4D systems gen4-uLCD-50 DCT Краткое руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Блок управления 4D systems gen4-uLCD-50 DCT. 4D systems gen4-uLCD-50 DCT 6 страниц. 5.0” slim intelligent display module with embedded diablo16 processor and resistive or capacitive touch panel
Печатать страницуQUICK START GUIDE
Follow steps 6b.1 to 6b.4 to scan and detect your display module
6b.1) Click on the COMMS tab, select the COM port the display module is connected
to from the dropdown list.
6b.2) Click on the RED Dot to start scanning for the display module. A YELLOW dot
will show while scanning. Make sure that your module is connected properly.
6b.3) Lastly, a successful detection will give you a BLUE Dot with the name of the
display module shown alongside it.
6b.4) Click on the Home tab to start creating your project.
Follow steps 6c.1 to 6c4 if you use Graphical User Images (GUI) on the Display
6c.1. Connect a uSD Card to your computer.
6c.2. Go to HOME tab and click the COMPILE button. Workshop 4 will prompt you to
select a drive to copy the image files to a uSD Card. After selecting the correct
drive, click OK. *NOTE: If you are using Visi-Genie Environment, go to HOME
tab and click the BUILD button.
6c.3. Remove the uSD Card from your computer and insert it into the uSD Card slot on
the gen4 HMI Display module. *NOTE: When the uSD card is not yet inserted,
this message will appear on the gen4 HMI Display Module: "Drive not mounted".
6c.4. After inserting the uSD card the GUI should appear on the gen4 Display.
Page 6 of 6