Düren tools 321275 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сандер Düren tools 321275. Düren tools 321275 7 страниц. Air operated 10mm belt sander
Печатать страницуPLEASE KEEP THIS MANUAL SAFE FOR FUTURE REFERENCE
4
It is strongly advised that you always use a Whip Hose/Leader Hose in combination with
Quick Release Couplings. See Fig. 2 for recommended setup.
5
Water in the air supply will cause the internal bearing of the tool to rust and eventually
Parts Diagram
seize.
6
Make sure that your airline is free from water at all times.
7
Always select the correct sanding disc grit for the job.
Tools Included with your Sander
1 x High Flow Male Air Fitting
Maintenance
1
If the air supply is not lubricated sufficiently it will be necessary to lubricate the tool
directly. This can be done by disconnecting the air hose and pouring in 5ml of air tool oil
into the Air Inlet. Read safety data sheet or instructions on use of oil to ensure safe
usage. These can be obtained from your supplier.
Extension Arm
2
Replace worn or damaged parts using genuine parts only.
3
Store tool in a dry area, do not allow tool to be immerse in water or used/stored in wet
conditions.
Sanding Belt
Tensioning
Pulley
Accessories (Not Shown):
2 x Sanding Belt (60 grit)
Hex Key
Angle
Adjustment
Screw
Tensioning Lever
Tensioning
Arm
T: 01582 484875 E: [email protected]
www.duren.co.uk
Handle
Duren Tools
Air Inlet
Exhaust
Quick
Connector