Abusemark LCD Руководство - Страница 5
Просмотреть онлайн или скачать pdf Руководство для Адаптер Abusemark LCD. Abusemark LCD 5 страниц.
Также для Abusemark LCD: Краткое руководство по эксплуатации (5 страниц)
Печатать страницуAbuseMarK LCD Adapter Manual
LCD Adapter firmware features and
operation
When connected by USB or external 5V source, adapter defaults to full power on, with status LED
glowing BLUE.
One press on power button will switch to STANDBY mode, which turns off backlight, but keeps
DisplayPort connection. This mode is used to keep power consumption lower, or to save backlight
lifetime. In this mode, status LED is glowing RED.
To fully turn off the adapter (including disconnect from DisplayPort signals), press the power button
twice.
●→●→☀ (BLUE – full power on ‐> RED – standby ‐> Full power off (LED off)
Since most common use case does not involve disconnecting from DisplayPort (as this would cause
other monitors to flicker while display adapter is reconfiguring), if adapter is in standby mode for more
than a few seconds, pressing the power button returns to Full power mode, turning on backlight.
●→●→Wait 2+ seconds→● (BLUE – full power on ‐> RED – standby ‐> if monitor is in standby for a
few seconds, pressing Power again will go back to FULL power mode (BLUE LED).
To change brightness, press and hold the power button for more than a second. This enters brightness
control mode. In this mode, status led glowing cycles between 2 colors ‐ YELLOW means brightness
DOWN adjustment, and PURPLE means brightness UP adjustment. Once in brightness adjustment mode,
short clicks on power button will adjust brightness in steps up or down respectively. Hold power button
again to switch to next mode, or to save.
●→●→●→● When required brightness is achieved, hold the button until status LED is glowing BLUE.
This will save current brightness to non‐volatile memory.
Other features may be added via firmware updates at a later time.
This information is current as of 2014/02/17
02/17/2013