Duro Dyne DynaTite CL12-WC3 Инструкции по установке

Просмотреть онлайн или скачать pdf Инструкции по установке для Системы управления Duro Dyne DynaTite CL12-WC3. Duro Dyne DynaTite CL12-WC3 2 страницы.

Печатать страницу

Looped Cable

Assembly

Step #1: Pass the end of the wire rope

around the anchor point and through

the cable loop.

Step 2: Using the appropriate cable lock

(see the chart on back), pull adjustment

pin back and pass the end of the wire rope

through the Dyna-Tite Cable Lock.

ALWAYS CONFIRM ENGAGEMENT OF CABLE LOCK ON WIRE BEFORE APPLYING LOAD

*When using Dyna-Stud Drop-In

Step 1: Insert a carbide tip

CAUTION

masonry bit into the ham-

mer-drill chuck and tighten

it in place.

Before

the hole to be drilled can

easily be set by using the

starting

depth gauge on the drill

to drill the

or by wrapping the bit with

hole, it is

tape at the required depth.

Make sure that the hole

important

depth will allow the anchor

that eye

to be flush with the surface

and ear

of the concrete.

protection

are used.

End Fixings Installation Instructions

Step 1:

a convenient anchor point with

appropriate fastener.

Step 3: Loop the wire rope around the duc-

twork or through attachment bracket and

back up through the Cable Lock.

Step 2:

Make sure the

hammer drill is in the

hammer mode and start

The depth of

drilling your hole. Continue

drilling until the tape on the

bit or the drill gauge meets

the base material - this

means that the required

depth has been reached.

Eyelets

Attach the wire rope to

Step 3: Before proceeding

with installation, the hole

must be cleaned of all

concrete dust to ensure

proper fastening. Use a

wire brush, a vacuum or

compressed air to clean

out the hole completely.

Swaged

'L'

Dyna-Stud

CABLE

(LISTED)

45° EYELET

(LISTED)

'L'

CABLE

90° EYELET

(LISTED)

'L'

1-1/2"

CABLE

(LISTED)

BRACKET w/DRIVE PIN

Step 1: Insert and tighten the Dyna-

Stud into a threaded receptacle of the

corresponding size. A locking jam nut

is recommended to prevent the Dyna-

Stud from turning. *If using Drop-In

see instructions below.

(sold separately)

Step 5: Now, take the

Step 4: Next, insert the

setting tool and insert

drop-in anchor with the

open side up. Drop the

it into the anchor.

anchor into the hole. Tap

Strike the setting tool

lightly to get the anchor

with a hammer until

flush

with

the

base

the lip of the anchor

touches the lip of the

material.

setting tool. This will

ensure the anchor is

properly set.