Cavalli Audio Liquid Gold Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Усилитель Cavalli Audio Liquid Gold. Cavalli Audio Liquid Gold 17 страниц. Balanced differential solid state dynamic headphone amplifier

Печатать страницу

Operation

Your Liquid Gold® amplifier has been operated for at least 50 hours for quality control and to

give the components an opportunity to break in. However, most amplifiers don't fully settle,

open up, and "relax" until they are played for at least 100 to 150 hours of operation. The Liquid

Gold® also follows this timeline up to 200 hours (see page 3). Your new amp will continue to

improve with regard to bass impact, more open sound, warmth, and "sweetness," so we

strongly recommend that you accumulate these important hours on your Liquid Gold® Solid

State headphone amplifier by playing it as much as possible so that you may fully enjoy its

performance as soon as possible.

Your power inlet has been set for the voltage you specified.

1) Insert the power cord.

2) Flip the standby switch on the power inlet at the rear of the amplifier. The power switch

on the front panel should light white.

3) Pushing the power switch turns the amp on (see notes below about "The Power Switch").

The white LED to the left and under the power switch will light red indicating that the amp

is on. This LED is marked "W" for "Wait."

4) The power circuit will delay anywhere from 1-2 minutes depending on your line/mains

voltage before enabling the outputs. When the first delay is finished the "W" LED will turn

from red to white.

5) The second LED, labeled "H" for Headphones will light red.

6) During this time the various sensing circuits will wait until the DC offsets at the outputs have

stabilized to the point where no damage to your headphones can occur.

7) When these sensing circuits are ready, the "H" LED will light white. At this point the amp is

ready to use.

8) We recommend that you let the amp warm up for about 15-30 minutes before connecting

headphones and listening (although this is not required).

9) You can leave the amp in standby mode (power switch lit) for any length of time.

Important - Power Supply Internal Protection

The Liquid Gold's power supply has an automatic shutdown feature. The power supply

monitors the line/mains voltage. If it drops too low for satisfactory operation of the amp the PS

disconnects the headphones. When it does this the "H" LED will go from white to red indicating

the disconnect.

Page 5 of 16