Caviblaster 1228-G Руководство по эксплуатации и техническому обслуживанию - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Мойка высокого давления Caviblaster 1228-G. Caviblaster 1228-G 11 страниц.

Печатать страницу

smaller diameters of hose may degrade

performance.

If greater hose lengths are

required, larger diameter hose must be used.

5. Connect the gun to the high pressure

hose (Figure 15) and submerge the gun

in water.

6. Restart the feed pump (Figure 13).

7. It is recommended that the gun trigger

be in the open or "ON" position (Figure

19) when starting the engine. This will

prevent a pressure shock wave from

damaging the pump in the instant that

the engine is started.

Apply appropriate hearing protection prior to starting the

9. Insert the key into the ignition switch on the side of the engine (Figure 16). Pull the choke

knob (Figure 17) out to close the choke if the engine is cold or has not been running. If the

engine has been running and is warm, leave the choke open. Adjust the throttle lever (Figure

18) one-third of the way from "MIN" toward "MAX" for correct engine RPM. Turn the key

clockwise to the "START" position. If the engine does not start within 5 seconds, release the

key and wait at least 10 seconds before operating the starter again. When the engine starts,

release the key, allowing it to return to the "ON" position and open the choke if it is closed.

Figure 16

10. The system is now ready to operate (refer to photo on cover for overall system set-up).

Figure 17

Figure 15

engine.

Figure 18