Addvent AVAC9000 Инструкции по установке и руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Кондиционер Addvent AVAC9000. Addvent AVAC9000 17 страниц.
Также для Addvent AVAC9000: Инструкции по установке и руководство пользователя (19 страниц)
Печатать страницу
Drainage
During the process of cooling, some water will be extracted from the air into
the unit.
If the reservoir is full, both of the compressor and motor will stop and the units
would buzz (you can press any button to stop the buzz). The W.F. indicator
will flash to show you.
To make the cooling work again, please empty the water by one of the
following ways:
1. Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water
to drain out.
4. When the container is almost full,
replace the rubber plug in the drain hole
and empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten
the drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should
not be flashing.
If you wish to operate the unit without
the need to empty the water tank, please:
Remove the drain knob and rubber
plug and retain for future use.
Connect the drain tube supplied to the water outlet as shown and locate
the other end into a drain.
12
FIG. 15
FIG. 16