Durston Tools Quad Ringer Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Электроинструмент Durston Tools Quad Ringer. Durston Tools Quad Ringer 12 страниц.
Печатать страницу
Always wear eye protection. The coil winder can be permanently mounted to a bench or wall if you have
sufficient studio space. Alternatively, the coil winder can be mounted in a vice.
1. Select a mandrel that will be the inside diameter of your
jump rings. Insert the selected mandrel into the keyless
chuck with the wire holding hole just out of the chuck
jaws. Tighten the chuck.
2. Make a right-angle bend at the end of your wire and insert
it between two of the chuck jaws (or into the wire holding
hole – mandrels 4.5mm and above). Hold the wire firmly
in your left hand and turn the coil winder clockwise (up at
the front and down at the back) with your right hand.
3. Hold the wire against the coil (slightly to the right of the coil
end) to ensure a tight coil. A tight coil is necessary to make
good jump rings. Do not wind to the very end of your wire
as tension in the coil needs to be released carefully to avoid
injury to your fingers.
4. Remove the coil and trim the ends.
Making a Coil
2